aboutsummaryrefslogtreecommitdiffstats
path: root/target/linux/ramips/mt7621/profiles
Commit message (Collapse)AuthorAgeFilesLines
* ramips: Disable the SD driver by default on MT7621John Crispin2016-04-094-4/+4
| | | | | | | | | | | | | | | | The SD driver has been a long and dragging issue on the MT7621 platforms as it hasn't worked for months resulting in unbootable devices. Until it's fixed, disable it in the default profiles. Reports / Discussed here: https://dev.openwrt.org/ticket/21392 https://dev.openwrt.org/ticket/21834 https://dev.openwrt.org/ticket/21995 https://forum.openwrt.org/viewtopic.php?id=59092 Signed-off-by: Daniel Engberg <daniel.engberg.lists@pyret.net> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@49131 3c298f89-4303-0410-b956-a3cf2f4a3e73
* ramips: mt7621: fix Ubiquiti EdgeRouter X profileJohn Crispin2016-04-091-1/+2
| | | | | | | | Remove unnecessary packages to reduce image size so it fits in initramfs (to enable upgrading from factory firmware). Signed-off-by: Roman Yeryomin <roman@advem.lv> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@49127 3c298f89-4303-0410-b956-a3cf2f4a3e73
* ramips: mt7621: sync MQmaker WiTi profile name to dts nameJohn Crispin2016-04-091-3/+3
| | | | | | Signed-off-by: Roman Yeryomin <roman@advem.lv> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@49126 3c298f89-4303-0410-b956-a3cf2f4a3e73
* ramips: add support for Ubiquiti EdgeRouter X (UBNT-ERX)John Crispin2015-12-121-0/+17
| | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | This router is based on MT7621 SoC, no wifi, no usb, nand. Works: * Boots. * Ethernet. * Switch. * Button (reset). * Flashing OpenWrt from stock firmware. * Upgrading OpenWrt. Doesn't work: * No GPIO leds. All leds are controlled by switch, but stock firmware was able to control them. * SoC has crypto engine but no open driver. * SoC has nat acceleration, but no open driver. * This router has 2MB spi flash soldered in but MT nand/spi drivers do not support pin sharing, so it is not accessable and disabled. Stock firmware could read it and it was empty. * PoE out. Router has serial pins populated. If looking at the top of the router, then counting from Eth sockets pins go as: 'GND, RX, TX, GND'. 3.3v, 57600. U-boot bootloader supports tftpboot, controlled from serial. This router has two kernel partitions: 'live' and 'backup'. They are swapped during flashing (on both stock and OpenWrt). Active partition is controlled by a flag in a factory partition. U-boot has custom command to switch active kernel partition. Kernel partitions are 'bare flash' 3MB. Stock bootloader has no UBI support. Stock rootfs is UBIFS. Flashing procedure. Stock firmware uses custom kernel patch to mount squashfs from a file that is located on UBIFS volume. This makes wiping out this volume from within stock firmware difficult. Instead this patch builds image that is flashable by stock firmware and contains initrams image (with minimal set of packages to fit into kernel partition). Once this is flashed one can reboot into initramfs OpenWrt and use sysupgrade to flash OpenWrt including rootfs into nand. Note: factory image is only built if initramfs image is enabled. Signed-off-by: Nikolay Martynov <mar.kolya@gmail.com> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@47881 3c298f89-4303-0410-b956-a3cf2f4a3e73
* ramips: add additional support for MQmaker WiTi boardJohn Crispin2015-12-111-0/+20
| | | | | | | | | | | | | | The board is based on mt7621AT cpu, and has 16mb nor flash, 256mb of ram, 2 sata ports, microsd card slot, 1 USB 3.0 port and at least one 2.4 and one 5 ghz antenna. This is the 6th submission that adds support for XHCI in the device tree file, along with switching the location of the 2 radio's and addition of the kmod-i2c-mt7621 in the default packages of the profile. Signed-off-by: Sebastian Careba <nitroshift@yahoo.com> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@47845 3c298f89-4303-0410-b956-a3cf2f4a3e73
* ralink: add support for netis WF-2881John Crispin2015-11-241-0/+23
| | | | | | | | | | | | | | | | | | | | | | | | | netis WF-2881 is an MT7621AT based router with MT7602EN, MT7612EN. It has 128MB DDR3, 128MB SLC NAND FLASH, 5-port Gbps switch and 1x USB 3.0. The following patch adds support for this device. this device only works on top of UBI. Tested and working: * ethernet * both WiFi radios * USB 3.0 * buttons (reset button) * ethernet switch and USB diag LEDs * UART * GPIOs * sysupgrade Tested and not working * failsafe Signed-off-by: YounJae Rho <luxflow@live.com> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@47619 3c298f89-4303-0410-b956-a3cf2f4a3e73
* ramips: minor fixes for mt7621 profilesFelix Fietkau2015-11-072-4/+2
| | | | | | | | | * remove references to non-existing kmod-usb3-mt7621 * ZTB WG2626 doesn't have an RTC (thanks to Piotr Dymacz!) Signed-off-by: Daniel Golle <daniel@makrotopia.org> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@47407 3c298f89-4303-0410-b956-a3cf2f4a3e73
* ramips: add support for ZBT WG2626John Crispin2015-11-021-0/+20
| | | | | | Signed-off-by: Daniel Golle <daniel@makrotopia.org> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@47351 3c298f89-4303-0410-b956-a3cf2f4a3e73
* ramips: fix various mistakes in subtargets *.mk profilesJohn Crispin2015-08-173-10/+8
| | | | | | | | | | | | | | | | This patch: * fixes wrong indentation * fixes wrong names and descriptions (ex. Dlink -> D-Link) * changes filenames to manufacturer names * moves oem/unknown manufacturers boards to misc.mk profiles * combines profiles for boards from the same manufacturers in one file (ex. Olimex) * fix profile files structure (keep the same convention as in other targets, ex. ar71xx) in various .mk profiles, in ramips target. Signed-off-by: Piotr Dymacz <pepe2k@gmail.com> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@46631 3c298f89-4303-0410-b956-a3cf2f4a3e73
* ramips: add support for STORYLiNK SAP-G3200U3John Crispin2015-07-241-0/+18
| | | | | | | | | | | | | | | | | | | | | | | | | | STORYLiNK SAP-G3200U3 is an AC1200 router based on MT7621AT+MT7602EN+MT7612EN. It has 128MB DDR3, 8MB NOR FLASH, 5-port Gbps switch and 1x USB 3.0. The following patch adds support for this device. Tested and working: * ethernet * both WiFi radios * USB 3.0 * buttons * ethernet switch and USB diag LEDs * UART * GPIOs Tested and not working: * LEDs for WiFi radios (connected with WiFi chips, not supported in mt76?) * failsafe mode (known problem, needs workaround like other MTK based devices) More information in Wiki: http://wiki.openwrt.org/toh/storylink/sap-g3200u3 Signed-off-by: Piotr Dymacz <pepe2k@gmail.com> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@46454 3c298f89-4303-0410-b956-a3cf2f4a3e73
* ramips: enable mt76 by default for mt7621Felix Fietkau2015-07-183-3/+2
| | | | | | Signed-off-by: Felix Fietkau <nbd@openwrt.org> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@46410 3c298f89-4303-0410-b956-a3cf2f4a3e73
* ramips: Add Support for the Linksys RE6500John Crispin2015-06-181-0/+16
| | | | | | | | | | This patch adds support for the Linksys RE6500 Range Extender http://wiki.openwrt.org/toh/linksys/re6500 Signed-off-by: L. D. Pinney <ldpinney@gmail.com> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@46043 3c298f89-4303-0410-b956-a3cf2f4a3e73
* ramips: add support for PandoraBox PBR-M1John Crispin2015-06-181-0/+22
| | | | | | | | | This patch is for PandoraBox PBR-M1 which is based on mt7621, all the features work fine, including rtc, leds, button, usb3.0, etc. Signed-off-by: tymon <banglang.huang@foxmail.com> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@46041 3c298f89-4303-0410-b956-a3cf2f4a3e73
* ralink: cleanup firefly default packagesJohn Crispin2015-02-021-8/+2
| | | | | | Signed-off-by: John Crispin <blogic@openwrt.org> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@44244 3c298f89-4303-0410-b956-a3cf2f4a3e73
* ralink: add support for firewrtJohn Crispin2015-01-201-0/+24
| | | | | | | | this is a mt7621 based board Signed-off-by: wengbj <linux.c@foxmail.com> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@44055 3c298f89-4303-0410-b956-a3cf2f4a3e73
* ralink: refresh patchesJohn Crispin2014-03-181-1/+1
| | | | | | Signed-off-by: John Crispin <blogic@openwrt.org> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@39949 3c298f89-4303-0410-b956-a3cf2f4a3e73
* ralink: add mt7621 supportJohn Crispin2013-12-131-0/+18
there are still various missing pieces for full support. Signed-off-by: John Crispin <blogic@openwrt.org> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@39040 3c298f89-4303-0410-b956-a3cf2f4a3e73
generated by cgit v1.2.3 (git 2.25.1) at 2024-07-09 23:17:23 +0000