openwrt/upstream - upstream openwrt

	Commit message (Collapse)	Author	Age	Files	Lines
*	ath79: Move DEVICE_VENDOR for NETGEAR to parent definition	Adrian Schmutzler	2019-07-04	1	-0/+1
\| \| \| \|	Signed-off-by: Adrian Schmutzler <freifunk@adrianschmutzler.de>
*	ath79: add support for Netgear EX6400 and EX7300	Daniel Gimpelevich	2019-04-09	1	-0/+10
\| \| \| \| \| \| \| \| \| \| \| \| \| \| \| \| \| \| \| \| \| \| \| \| \| \| \| \|	This is sold as a dual-band 802.11ac range extender. It has a sliding switch for Extender mode or Access Point mode, a WPS button, a recessed Reset button, a hard-power button, and a multitude of LED's, some multiplexed via an NXP 74AHC164D chip. The internal serial header pinout is Vcc, Tx, Rx, GND, with GND closest to the corner of the board. You may connect at 115200 bps, 8 data bits, no parity, 1 stop bit. Specification: - System-On-Chip: QCA9558 - CPU/Speed: 720 MHz - Flash-Chip: Winbond 25Q128FVSG - Flash size: 16 MiB - RAM: 128 MiB - Wireless No1: QCA9558 on-chip 2.4GHz 802.11bgn, 3x3 - Wireless No2: QCA99x0 chip 5GHz 802.11an+ac, 4x4 - PHY: Atheros AR8035-A Installation: If you can get to the stock firmware's firmware upgrade option, just feed it the factory.img and boot as usual. As an alternative, TFTP the factory.img to the bootloader. Signed-off-by: Daniel Gimpelevich <daniel@gimpelevich.san-francisco.ca.us> [whitespace fix in DTS and reorder of make variables] Signed-off-by: Petr Štetiar <ynezz@true.cz>
*	ath79: remove more duplicate image build variables	Daniel Gimpelevich	2019-04-09	1	-0/+7
\| \| \| \| \| \| \| \| \|	Remove Netgear-specific image build variables which are set to the same value. Signed-off-by: Daniel Gimpelevich <daniel@gimpelevich.san-francisco.ca.us> [reordering of variables, removed stray newline] Signed-off-by: Petr Štetiar <ynezz@true.cz>
*	ath79: mark netgear variables as device specific	Mathias Kresin	2018-08-08	1	-0/+2
\| \| \| \| \| \| \| \|	The variables are used in image build recipes and need to be marked as per devices vars to be stored individual per image define. Otherwise the last defined variable will be used for all boards. Signed-off-by: Mathias Kresin <dev@kresin.me>
*	ath79: move Netgear build code into a common makefile	Zoltan HERPAI	2018-06-18	1	-0/+22
	Signed-off-by: Zoltan HERPAI <wigyori@uid0.hu>