aboutsummaryrefslogtreecommitdiffstats
path: root/target/linux/generic/pending-5.15/850-0013-PCI-aardvark-Add-support-for-ERR-interrupt-on-emulat.patch
blob: 4a552a2ed3519f5f0cb1a346a1136e21e761931c (plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
From 7f3e55a3890fa26d15e2e4e90213962d1a7f6df9 Mon Sep 17 00:00:00 2001
From: =?UTF-8?q?Pali=20Roh=C3=A1r?= <pali@kernel.org>
Date: Fri, 12 Feb 2021 20:32:55 +0100
Subject: [PATCH] PCI: aardvark: Add support for ERR interrupt on emulated
 bridge
MIME-Version: 1.0
Content-Type: text/plain; charset=UTF-8
Content-Transfer-Encoding: 8bit

ERR interrupt is triggered when corresponding bit is unmasked in both ISR0
and PCI_EXP_DEVCTL registers. Unmasking ERR bits in PCI_EXP_DEVCTL register
is not enough. This means that currently the ERR interrupt is never
triggered.

Unmask ERR bits in ISR0 register at driver probe time. ERR interrupt is not
triggered until ERR bits are unmasked also in PCI_EXP_DEVCTL register,
which is done by AER driver. So it is safe to unconditionally unmask all
ERR bits in aardvark probe.

Aardvark HW sets PCI_ERR_ROOT_AER_IRQ to zero and when corresponding bits
in ISR0 and PCI_EXP_DEVCTL are enabled, the HW triggers a generic interrupt
on GIC. Chain this interrupt to PCIe interrupt 0 with
generic_handle_domain_irq() to allow processing of ERR interrupts.

Signed-off-by: Pali Rohár <pali@kernel.org>
Signed-off-by: Marek Behún <kabel@kernel.org>
---
 drivers/pci/controller/pci-aardvark.c | 36 ++++++++++++++++++++++++++-
 1 file changed, 35 insertions(+), 1 deletion(-)

--- a/drivers/pci/controller/pci-aardvark.c
+++ b/drivers/pci/controller/pci-aardvark.c
@@ -98,6 +98,10 @@
 #define PCIE_MSG_PM_PME_MASK			BIT(7)
 #define PCIE_ISR0_MASK_REG			(CONTROL_BASE_ADDR + 0x44)
 #define     PCIE_ISR0_MSI_INT_PENDING		BIT(24)
+#define     PCIE_ISR0_CORR_ERR			BIT(11)
+#define     PCIE_ISR0_NFAT_ERR			BIT(12)
+#define     PCIE_ISR0_FAT_ERR			BIT(13)
+#define     PCIE_ISR0_ERR_MASK			GENMASK(13, 11)
 #define     PCIE_ISR0_INTX_ASSERT(val)		BIT(16 + (val))
 #define     PCIE_ISR0_INTX_DEASSERT(val)	BIT(20 + (val))
 #define     PCIE_ISR0_ALL_MASK			GENMASK(31, 0)
@@ -778,11 +782,15 @@ advk_pci_bridge_emul_base_conf_read(stru
 	case PCI_INTERRUPT_LINE: {
 		/*
 		 * From the whole 32bit register we support reading from HW only
-		 * one bit: PCI_BRIDGE_CTL_BUS_RESET.
+		 * two bits: PCI_BRIDGE_CTL_BUS_RESET and PCI_BRIDGE_CTL_SERR.
 		 * Other bits are retrieved only from emulated config buffer.
 		 */
 		__le32 *cfgspace = (__le32 *)&bridge->conf;
 		u32 val = le32_to_cpu(cfgspace[PCI_INTERRUPT_LINE / 4]);
+		if (advk_readl(pcie, PCIE_ISR0_MASK_REG) & PCIE_ISR0_ERR_MASK)
+			val &= ~(PCI_BRIDGE_CTL_SERR << 16);
+		else
+			val |= PCI_BRIDGE_CTL_SERR << 16;
 		if (advk_readl(pcie, PCIE_CORE_CTRL1_REG) & HOT_RESET_GEN)
 			val |= PCI_BRIDGE_CTL_BUS_RESET << 16;
 		else
@@ -808,6 +816,19 @@ advk_pci_bridge_emul_base_conf_write(str
 		break;
 
 	case PCI_INTERRUPT_LINE:
+		/*
+		 * According to Figure 6-3: Pseudo Logic Diagram for Error
+		 * Message Controls in PCIe base specification, SERR# Enable bit
+		 * in Bridge Control register enable receiving of ERR_* messages
+		 */
+		if (mask & (PCI_BRIDGE_CTL_SERR << 16)) {
+			u32 val = advk_readl(pcie, PCIE_ISR0_MASK_REG);
+			if (new & (PCI_BRIDGE_CTL_SERR << 16))
+				val &= ~PCIE_ISR0_ERR_MASK;
+			else
+				val |= PCIE_ISR0_ERR_MASK;
+			advk_writel(pcie, val, PCIE_ISR0_MASK_REG);
+		}
 		if (mask & (PCI_BRIDGE_CTL_BUS_RESET << 16)) {
 			u32 val = advk_readl(pcie, PCIE_CORE_CTRL1_REG);
 			if (new & (PCI_BRIDGE_CTL_BUS_RESET << 16))
@@ -1459,6 +1480,19 @@ static void advk_pcie_handle_int(struct
 	isr1_mask = advk_readl(pcie, PCIE_ISR1_MASK_REG);
 	isr1_status = isr1_val & ((~isr1_mask) & PCIE_ISR1_ALL_MASK);
 
+	/* Process ERR interrupt */
+	if (isr0_status & PCIE_ISR0_ERR_MASK) {
+		advk_writel(pcie, PCIE_ISR0_ERR_MASK, PCIE_ISR0_REG);
+
+		/*
+		 * Aardvark HW returns zero for PCI_ERR_ROOT_AER_IRQ, so use
+		 * PCIe interrupt 0
+		 */
+		virq = irq_find_mapping(pcie->irq_domain, 0);
+		if (generic_handle_irq(virq) == -EINVAL)
+			dev_err_ratelimited(&pcie->pdev->dev, "unhandled ERR IRQ\n");
+	}
+
 	/* Process MSI interrupts */
 	if (isr0_status & PCIE_ISR0_MSI_INT_PENDING)
 		advk_pcie_handle_msi(pcie);