blob: 3e5a4ebf01a078f599368fea1d0ed47d96867b1e (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
|
--- linux-2.6.27/drivers/net/au1000_eth.c 2008-10-18 22:37:52.000000000 +0200
+++ linux-2.6.27.new/drivers/net/au1000_eth.c 2008-11-02 22:03:14.000000000 +0100
@@ -187,6 +187,15 @@
# undef AU1XXX_PHY1_IRQ
#endif
+#if defined(CONFIG_MIPS_MTX1)
+/*
+ * 4G MeshCube (MTX-1) board
+ * PHY is at address 31 on MAC0
+ * autodetect fails if not searched for highest address !
+ */
+# define AU1XXX_PHY_SEARCH_HIGHEST_ADDR
+#endif
+
#if defined(AU1XXX_PHY0_BUSID) && (AU1XXX_PHY0_BUSID > 0)
# error MAC0-associated PHY attached 2nd MACs MII bus not supported yet
#endif
@@ -383,6 +392,12 @@
aup->old_duplex = -1;
aup->phy_dev = phydev;
+#ifdef CONFIG_MIPS_MTX1
+ /* set up ethernet jack LEDs on the 4G MeshCube (MTX-1 board) */
+ printk(KERN_INFO "MTX-1 PHY: updating LED settings\n");
+ phy_write(phydev, 0x11, 0xff80);
+#endif
+
printk(KERN_INFO "%s: attached PHY driver [%s] "
"(mii_bus:phy_addr=%s, irq=%d)\n",
dev->name, phydev->drv->name, phydev->dev.bus_id, phydev->irq);
|
