aboutsummaryrefslogtreecommitdiffstats
path: root/target/linux/ath79
diff options
context:
space:
mode:
authorRoger Pueyo Centelles <roger.pueyo@guifi.net>2020-12-18 22:26:55 +0100
committerKoen Vandeputte <koen.vandeputte@ncentric.com>2021-04-16 13:54:22 +0200
commit4387fe00cb7536d9d341f6d27e465ff0f0b29b1b (patch)
treec3389e7647696754b9638938e84d7b5a7860d416 /target/linux/ath79
parent41948c9c1b80e39f2fd2771f42e62e209347b0bf (diff)
downloadupstream-4387fe00cb7536d9d341f6d27e465ff0f0b29b1b.tar.gz
upstream-4387fe00cb7536d9d341f6d27e465ff0f0b29b1b.tar.bz2
upstream-4387fe00cb7536d9d341f6d27e465ff0f0b29b1b.zip
ath79: mikrotik: enable SFP on RB922UAGS-5HPaCD
This patch enables the SFP cage on the MikroTik RouterBOARD 922UAGS-5HPacD. GPIO16 (tx-disable-gpios) should be governed by the SFP driver to enable or disable transmission, but no change is observed. Therefore, it is left as output high to ensure the SFP module is forced to transmit. Tested on a RouterBOARD 922UAGS-5HPacD board, with a CISCO GLC-LH-SMD 1310nm module and an unbranded GLC-T RJ45 Gigabit module. PC=>router iperf3 tests deliver 440/300 Mbps up/down, both via regular eth0 port or SFP port with RJ45 module. Bridge between eth0 and eth1 delivers 950 Mbps symmetric. Signed-off-by: Roger Pueyo Centelles <roger.pueyo@guifi.net>
Diffstat (limited to 'target/linux/ath79')
-rw-r--r--target/linux/ath79/dts/qca9558_mikrotik_routerboard-922uags-5hpacd.dts48
-rw-r--r--target/linux/ath79/image/mikrotik.mk3
-rw-r--r--target/linux/ath79/mikrotik/base-files/etc/board.d/02_network1
-rw-r--r--target/linux/ath79/mikrotik/config-default1
4 files changed, 51 insertions, 2 deletions
diff --git a/target/linux/ath79/dts/qca9558_mikrotik_routerboard-922uags-5hpacd.dts b/target/linux/ath79/dts/qca9558_mikrotik_routerboard-922uags-5hpacd.dts
index 8ad834fe61..36979bbd33 100644
--- a/target/linux/ath79/dts/qca9558_mikrotik_routerboard-922uags-5hpacd.dts
+++ b/target/linux/ath79/dts/qca9558_mikrotik_routerboard-922uags-5hpacd.dts
@@ -23,6 +23,27 @@
gpios = <&gpio 13 GPIO_ACTIVE_HIGH>;
};
};
+
+ i2c: i2c {
+ compatible = "i2c-gpio";
+
+ sda-gpios = <&gpio 18 (GPIO_ACTIVE_HIGH|GPIO_OPEN_DRAIN)>;
+ scl-gpios = <&gpio 19 (GPIO_ACTIVE_HIGH|GPIO_OPEN_DRAIN)>;
+ i2c-gpio,delay-us = <5>;
+ i2c-gpio,timeout-ms = <1>;
+ };
+
+ sfp1: sfp {
+ compatible = "sff,sfp";
+
+ i2c-bus = <&i2c>;
+ maximum-power-milliwatt = <1000>;
+ los-gpios = <&gpio 21 GPIO_ACTIVE_HIGH>;
+ mod-def0-gpios = <&gpio 17 GPIO_ACTIVE_LOW>;
+ tx-disable-gpios = <&gpio 16 GPIO_ACTIVE_HIGH>;
+ // Toggling GPIO16 actually enables/disables the transmitter,
+ // but the SFP driver does not seem to be using it.
+ };
};
&pcie0 {
@@ -55,3 +76,30 @@
&usb_phy1 {
status = "okay";
};
+
+&mdio1 {
+ status = "okay";
+
+ phy_sfp: ethernet-phy@0 {
+ reg = <0>;
+ phy-mode = "sgmii";
+ sfp = <&sfp1>;
+ };
+};
+
+&eth1 {
+ status = "okay";
+
+ phy-handle = <&phy_sfp>;
+ pll-data = <0x03000000 0x00000101 0x00001616>;
+ qca955x-sgmii-fixup;
+
+ gmac-config {
+ device = <&gmac>;
+ };
+
+ fixed-link {
+ speed = <1000>;
+ full-duplex;
+ };
+};
diff --git a/target/linux/ath79/image/mikrotik.mk b/target/linux/ath79/image/mikrotik.mk
index b7d745bc77..74f8603b5a 100644
--- a/target/linux/ath79/image/mikrotik.mk
+++ b/target/linux/ath79/image/mikrotik.mk
@@ -22,7 +22,8 @@ define Device/mikrotik_routerboard-922uags-5hpacd
$(Device/mikrotik_nand)
SOC := qca9558
DEVICE_MODEL := RouterBOARD 922UAGS-5HPacD
- DEVICE_PACKAGES += kmod-ath10k-ct ath10k-firmware-qca988x-ct kmod-usb2
+ DEVICE_PACKAGES += kmod-ath10k-ct ath10k-firmware-qca988x-ct kmod-usb2 \
+ kmod-i2c-gpio kmod-sfp
SUPPORTED_DEVICES += rb-922uags-5hpacd
endef
TARGET_DEVICES += mikrotik_routerboard-922uags-5hpacd
diff --git a/target/linux/ath79/mikrotik/base-files/etc/board.d/02_network b/target/linux/ath79/mikrotik/base-files/etc/board.d/02_network
index d229523ad5..835e2caf93 100644
--- a/target/linux/ath79/mikrotik/base-files/etc/board.d/02_network
+++ b/target/linux/ath79/mikrotik/base-files/etc/board.d/02_network
@@ -15,7 +15,6 @@ ath79_setup_interfaces()
"0@eth1" "1:lan:4" "2:lan:1" "3:lan:2" "4:lan:3"
;;
mikrotik,routerboard-921gs-5hpacd-15s|\
- mikrotik,routerboard-922uags-5hpacd|\
mikrotik,routerboard-lhg-2nd|\
mikrotik,routerboard-sxt-5nd-r2|\
mikrotik,routerboard-wap-g-5hact2hnd|\
diff --git a/target/linux/ath79/mikrotik/config-default b/target/linux/ath79/mikrotik/config-default
index c70ae75b01..b89ef5f8ed 100644
--- a/target/linux/ath79/mikrotik/config-default
+++ b/target/linux/ath79/mikrotik/config-default
@@ -24,6 +24,7 @@ CONFIG_MTD_UBI=y
CONFIG_MTD_UBI_BLOCK=y
CONFIG_MTD_UBI_WL_THRESHOLD=4096
CONFIG_MTD_UBI_BEB_LIMIT=20
+CONFIG_NET_DSA=y
CONFIG_NET_SWITCHDEV=y
CONFIG_PCI_AR71XX=y
CONFIG_PHY_AR7100_USB=y