diff options
Diffstat (limited to 'drivers/mtd/ubi/Kconfig')
| -rw-r--r-- | drivers/mtd/ubi/Kconfig | 63 |
1 files changed, 63 insertions, 0 deletions
diff --git a/drivers/mtd/ubi/Kconfig b/drivers/mtd/ubi/Kconfig new file mode 100644 index 00000000..4dcc752a --- /dev/null +++ b/drivers/mtd/ubi/Kconfig @@ -0,0 +1,63 @@ +menuconfig MTD_UBI + tristate "Enable UBI - Unsorted block images" + select CRC32 + help + UBI is a software layer above MTD layer which admits of LVM-like + logical volumes on top of MTD devices, hides some complexities of + flash chips like wear and bad blocks and provides some other useful + capabilities. Please, consult the MTD web site for more details + (www.linux-mtd.infradead.org). + +if MTD_UBI + +config MTD_UBI_WL_THRESHOLD + int "UBI wear-leveling threshold" + default 4096 + range 2 65536 + help + This parameter defines the maximum difference between the highest + erase counter value and the lowest erase counter value of eraseblocks + of UBI devices. When this threshold is exceeded, UBI starts performing + wear leveling by means of moving data from eraseblock with low erase + counter to eraseblocks with high erase counter. + + The default value should be OK for SLC NAND flashes, NOR flashes and + other flashes which have eraseblock life-cycle 100000 or more. + However, in case of MLC NAND flashes which typically have eraseblock + life-cycle less than 10000, the threshold should be lessened (e.g., + to 128 or 256, although it does not have to be power of 2). + +config MTD_UBI_BEB_RESERVE + int "Percentage of reserved eraseblocks for bad eraseblocks handling" + default 1 + range 0 25 + help + If the MTD device admits of bad eraseblocks (e.g. NAND flash), UBI + reserves some amount of physical eraseblocks to handle new bad + eraseblocks. For example, if a flash physical eraseblock becomes bad, + UBI uses these reserved physical eraseblocks to relocate the bad one. + This option specifies how many physical eraseblocks will be reserved + for bad eraseblock handling (percents of total number of good flash + eraseblocks). If the underlying flash does not admit of bad + eraseblocks (e.g. NOR flash), this value is ignored and nothing is + reserved. Leave the default value if unsure. + +config MTD_UBI_GLUEBI + tristate "MTD devices emulation driver (gluebi)" + help + This option enables gluebi - an additional driver which emulates MTD + devices on top of UBI volumes: for each UBI volumes an MTD device is + created, and all I/O to this MTD device is redirected to the UBI + volume. This is handy to make MTD-oriented software (like JFFS2) + work on top of UBI. Do not enable this unless you use legacy + software. + +config MTD_UBI_DEBUG + bool "UBI debugging" + depends on SYSFS + select DEBUG_FS + select KALLSYMS + help + This option enables UBI debugging. + +endif # MTD_UBI |