1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
|
.. _QuickStart:hello:
`Hello world` program
=====================
To illustrate the general purpose of `VHDL`, the following block is a commented `Hello world` program which is saved in
a file named :file:`hello.vhdl`:
.. literalinclude:: hello.vhdl
:language: vhdl
.. TIP::
* Both ``.vhdl`` and ``.vhd`` extensions are used for `VHDL` source files, while ``.v`` is used for Verilog.
* Since, extension ``.vhd`` is also interpreted as a `Virtual Hard Disk <https://en.wikipedia.org/wiki/VHD_(file_format)>`_
file format, some users prefer ``.vhdl``, to avoid ambiguity. This is the case with `GHDL`'s codebase. However, in order
to maintain `backward-compatibility <https://en.wikipedia.org/wiki/8.3_filename>`_ with legacy DOS systems,
other users prefer ``.vhd``.
* Unless you use especial characters, either `UTF-8` or `ISO-8859-1` encodings can be used. However, if you do, the
latter should be used. The standard defines ASCII (7-bit encoding) or ISO Latin-1 (ISO-8859-1) as default.
However, GHDL has a relaxing option, :option:`--mb-comments` (multi byte), to allow UTF-8 or other encodings in
comments.
- First, you have to compile the file; this is called :ref:`analysis <Analysis:command>` of a design file in `VHDL`
terms. Run ``ghdl -a hello.vhdl`` in the `shell`. This command creates or updates a file :file:`work-obj93.cf`, which
describes the library ``work``.
- Then, run ``ghdl -e hello_world`` in the `shell`. Command :option:`-e` means :ref:`elaborate <Elaboration:command>`,
which is used to build a design, with the ``hello_world`` entity at the top of the hierarchy.
- Last, you can directly launch the simulation :ref:`running <Run:command>` ``ghdl -r hello_world`` in the `shell`. The
result of the simulation will be shown on screen:
.. code-block:: shell
Hello world!
.. HINT::
If a GCC/LLVM variant of `GHDL` is used:
* :ref:`Analysis <Analysis:command>` generates a file, :file:`hello.o`, which is the object file corresponding to
your `VHDL` program. This is not created with :ref:`mcode <BUILD>`. These kind of object files can be
compiled into foreign programs (see :ref:`Linking_with_Ada`).
* The :ref:`elaboration <Elaboration:command>` step is mandatory after running the analysis and prior to launching the
simulation. This will generate an executable binary named :file:`hello_world`.
* As a result, :option:`-r` is just a passthrough to the binary generated in the `elaboration`. Therefore, the
executable can be run directly: ``./hello_world``. See :option:`-r` for more informartion.
.. HINT::
:option:`-e` can be bypassed with :ref:`mcode <BUILD>`, since :option:`-r` actually elaborates the design and saves
it on memory before running the simulation. But you can still use it to check for some elaboration problems.
|
