diff options
Diffstat (limited to 'flashrom.8')
-rw-r--r-- | flashrom.8 | 36 |
1 files changed, 36 insertions, 0 deletions
@@ -198,6 +198,9 @@ based programmer)" .BR "* nicintel_spi" " (for SPI flash ROMs attached to an Intel Gigabit \ network cards)" .sp +.BR "* ogp_spi" " (for SPI flash ROMs attached to an Open Graphics Project \ +graphics card)" +.sp Some programmers have optional or mandatory parameters which are described in detail in the .B PROGRAMMER SPECIFIC INFO @@ -432,6 +435,34 @@ four. Make sure to not forget the "0x" prefix for hexadecimal port addresses. .sp More information about the hardware is available at http://rayer.ic.cz/elektro/spipgm.htm +.TP +.BR "ogp_spi " programmer +The FLASH ROM chip to access must be specified with the +.B rom +parameter. +.sp +.B " flashrom \-p ogp_spi:rom=name" +.sp +Where +.B name +is either +.B cprom +or +.B s3 +for the configuration ROM and +.B bprom +or +.B bios +for the BIOS ROM. If more than one card supported by the ogp_spi programmer +is installed in your system, you have to specify the PCI address of the card +you want to use with the +.B pci= +parameter as explained in the +.B nic3com +section above. +.sp +More information about the hardware is available at +http://wiki.opengraphics.org .SH EXIT STATUS flashrom exits with 0 on success, 1 on most failures but with 2 if /dev/mem (/dev/xsvc on Solaris) can not be opened and with 3 if a call to mmap() fails. @@ -480,6 +511,9 @@ have to be run as superuser/root, and need additional raw access permission. can be run as normal user on most operating systems if appropriate device permissions are set. .sp +.B ogp +needs PCI configuration space read access and raw memory access. +.sp On OpenBSD, you can obtain raw access permission by setting securelevel=-1 in /etc/rc.securelevel and rebooting, or rebooting into single user mode. @@ -538,6 +572,8 @@ Luc Verhaegen .br Li-Ta Lo .br +Mark Marshall +.br Markus Boas .br Mattias Mattsson |