diff options
Diffstat (limited to 'roms/u-boot/board/phytec/pcm030/pcm030.c')
| -rw-r--r-- | roms/u-boot/board/phytec/pcm030/pcm030.c | 203 |
1 files changed, 203 insertions, 0 deletions
diff --git a/roms/u-boot/board/phytec/pcm030/pcm030.c b/roms/u-boot/board/phytec/pcm030/pcm030.c new file mode 100644 index 00000000..ce515d83 --- /dev/null +++ b/roms/u-boot/board/phytec/pcm030/pcm030.c @@ -0,0 +1,203 @@ +/* + * (C) Copyright 2003 + * Wolfgang Denk, DENX Software Engineering, wd@denx.de. + * + * (C) Copyright 2004 + * Mark Jonas, Freescale Semiconductor, mark.jonas@motorola.com. + * + * (C) Copyright 2006 + * Eric Schumann, Phytec Messtechnik GmbH + * + * SPDX-License-Identifier: GPL-2.0+ + */ + +#include <common.h> +#include <mpc5xxx.h> +#include <pci.h> +#include <asm/io.h> + +#include "mt46v32m16-75.h" + +#ifndef CONFIG_SYS_RAMBOOT +static void sdram_start(int hi_addr) +{ + volatile struct mpc5xxx_cdm *cdm = + (struct mpc5xxx_cdm *)MPC5XXX_CDM; + volatile struct mpc5xxx_sdram *sdram = + (struct mpc5xxx_sdram *)MPC5XXX_SDRAM; + + long hi_addr_bit = hi_addr ? 0x01000000 : 0; + + /* unlock mode register */ + out_be32 (&sdram->ctrl, + (SDRAM_CONTROL | 0x80000000 | hi_addr_bit)); + + /* precharge all banks */ + out_be32 (&sdram->ctrl, + (SDRAM_CONTROL | 0x80000002 | hi_addr_bit)); + +#ifdef SDRAM_DDR + /* set mode register: extended mode */ + out_be32 (&sdram->mode, (SDRAM_EMODE)); + + /* set mode register: reset DLL */ + out_be32 (&sdram->mode, + (SDRAM_MODE | 0x04000000)); +#endif + + /* precharge all banks */ + out_be32 (&sdram->ctrl, + (SDRAM_CONTROL | 0x80000002 | hi_addr_bit)); + + /* auto refresh */ + out_be32 (&sdram->ctrl, + (SDRAM_CONTROL | 0x80000004 | hi_addr_bit)); + + /* set mode register */ + out_be32 (&sdram->mode, (SDRAM_MODE)); + + /* normal operation */ + out_be32 (&sdram->ctrl, + (SDRAM_CONTROL | hi_addr_bit)); + + /* set CDM clock enable register, set MPC5200B SDRAM bus */ + /* to reduced driver strength */ + out_be32 (&cdm->clock_enable, (0x00CFFFFF)); +} +#endif + +/* + * ATTENTION: Although partially referenced initdram does NOT make + * real use of CONFIG_SYS_SDRAM_BASE. The code does not + * work if CONFIG_SYS_SDRAM_BASE + * is something else than 0x00000000. + */ + +phys_size_t initdram(int board_type) +{ + volatile struct mpc5xxx_mmap_ctl *mm = + (struct mpc5xxx_mmap_ctl *)CONFIG_SYS_MBAR; + volatile struct mpc5xxx_cdm *cdm = + (struct mpc5xxx_cdm *)MPC5XXX_CDM; + volatile struct mpc5xxx_sdram *sdram = + (struct mpc5xxx_sdram *)MPC5XXX_SDRAM; + ulong dramsize = 0; + ulong dramsize2 = 0; +#ifndef CONFIG_SYS_RAMBOOT + ulong test1, test2; + + /* setup SDRAM chip selects */ + /* 256MB at 0x0 */ + out_be32 (&mm->sdram0, 0x0000001b); + /* disabled */ + out_be32 (&mm->sdram1, 0x10000000); + + /* setup config registers */ + out_be32 (&sdram->config1, SDRAM_CONFIG1); + out_be32 (&sdram->config2, SDRAM_CONFIG2); + +#if defined(SDRAM_DDR) && defined(SDRAM_TAPDELAY) + /* set tap delay */ + out_be32 (&cdm->porcfg, SDRAM_TAPDELAY); +#endif + + /* find RAM size using SDRAM CS0 only */ + sdram_start(0); + test1 = get_ram_size((long *) CONFIG_SYS_SDRAM_BASE, 0x10000000); + sdram_start(1); + test2 = get_ram_size((long *) CONFIG_SYS_SDRAM_BASE, 0x10000000); + if (test1 > test2) { + sdram_start(0); + dramsize = test1; + } else + dramsize = test2; + + /* memory smaller than 1MB is impossible */ + if (dramsize < (1 << 20)) + dramsize = 0; + + /* set SDRAM CS0 size according to the amount of RAM found */ + if (dramsize > 0) { + out_be32 (&mm->sdram0, + (0x13 + __builtin_ffs(dramsize >> 20) - 1)); + } else { + /* disabled */ + out_be32 (&mm->sdram0, 0); + } + +#else /* CONFIG_SYS_RAMBOOT */ + + /* retrieve size of memory connected to SDRAM CS0 */ + dramsize = in_be32(&mm->sdram0) & 0xFF; + if (dramsize >= 0x13) + dramsize = (1 << (dramsize - 0x13)) << 20; + else + dramsize = 0; + + /* retrieve size of memory connected to SDRAM CS1 */ + dramsize2 = in_be32(&mm->sdram1) & 0xFF; + if (dramsize2 >= 0x13) + dramsize2 = (1 << (dramsize2 - 0x13)) << 20; + else + dramsize2 = 0; + +#endif /* CONFIG_SYS_RAMBOOT */ + + return dramsize + dramsize2; +} + +int checkboard(void) +{ + puts("Board: phyCORE-MPC5200B-tiny\n"); + return 0; +} + +#ifdef CONFIG_PCI +static struct pci_controller hose; + +extern void pci_mpc5xxx_init(struct pci_controller *); + +void pci_init_board(void) +{ + pci_mpc5xxx_init(&hose); +} +#endif + +#if defined(CONFIG_OF_LIBFDT) && defined(CONFIG_OF_BOARD_SETUP) +void ft_board_setup(void *blob, bd_t * bd) +{ + ft_cpu_setup(blob, bd); +} +#endif /* defined(CONFIG_OF_LIBFDT) && defined(CONFIG_OF_BOARD_SETUP) */ + +#if defined(CONFIG_CMD_IDE) && defined(CONFIG_IDE_RESET) + +#define GPIO_PSC2_4 0x02000000UL + +void init_ide_reset(void) +{ + volatile struct mpc5xxx_wu_gpio *wu_gpio = + (struct mpc5xxx_wu_gpio *)MPC5XXX_WU_GPIO; + debug("init_ide_reset\n"); + + /* Configure PSC2_4 as GPIO output for ATA reset */ + setbits_be32(&wu_gpio->enable, GPIO_PSC2_4); + setbits_be32(&wu_gpio->ddr, GPIO_PSC2_4); + /* Deassert reset */ + setbits_be32(&wu_gpio->dvo, GPIO_PSC2_4); +} + +void ide_set_reset(int idereset) +{ + volatile struct mpc5xxx_wu_gpio *wu_gpio = + (struct mpc5xxx_wu_gpio *)MPC5XXX_WU_GPIO; + debug("ide_reset(%d)\n", idereset); + + if (idereset) { + clrbits_be32(&wu_gpio->dvo, GPIO_PSC2_4); + /* Make a delay. MPC5200 spec says 25 usec min */ + udelay(500000); + } else + setbits_be32(&wu_gpio->dvo, GPIO_PSC2_4); +} +#endif /* defined(CONFIG_CMD_IDE) && defined(CONFIG_IDE_RESET) */ |