1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
194
195
196
197
198
199
200
201
202
203
204
205
206
207
208
209
210
211
212
213
214
215
216
217
218
219
220
221
222
223
224
225
226
227
228
229
230
231
232
233
234
235
236
237
238
239
240
241
242
243
244
245
246
247
|
From 7fa63fdde703aaabaa7199ae879219737a98a3f3 Mon Sep 17 00:00:00 2001
From: Jonas Gorski <jonas.gorski@gmail.com>
Date: Fri, 6 Jan 2012 12:24:18 +0100
Subject: [PATCH] NET: bcm63xx_enet: move phy_(dis)connect into probe/remove
Only connect/disconnect the phy during probe and remove, not during any
open/close. The phy seldom changes during the runtime, and disconnecting
the phy during close will prevent it from keeping any configuration over
a down/up cycle.
Signed-off-by: Jonas Gorski <jonas.gorski@gmail.com>
---
drivers/net/ethernet/broadcom/bcm63xx_enet.c | 158 +++++++++++++--------------
1 file changed, 78 insertions(+), 80 deletions(-)
--- a/drivers/net/ethernet/broadcom/bcm63xx_enet.c
+++ b/drivers/net/ethernet/broadcom/bcm63xx_enet.c
@@ -892,10 +892,8 @@ static int bcm_enet_open(struct net_devi
struct bcm_enet_priv *priv;
struct sockaddr addr;
struct device *kdev;
- struct phy_device *phydev;
int i, ret;
unsigned int size;
- char phy_id[MII_BUS_ID_SIZE + 3];
void *p;
u32 val;
@@ -903,31 +901,10 @@ static int bcm_enet_open(struct net_devi
kdev = &priv->pdev->dev;
if (priv->has_phy) {
- /* connect to PHY */
- snprintf(phy_id, sizeof(phy_id), PHY_ID_FMT,
- priv->mii_bus->id, priv->phy_id);
-
- phydev = phy_connect(dev, phy_id, bcm_enet_adjust_phy_link,
- PHY_INTERFACE_MODE_MII);
-
- if (IS_ERR(phydev)) {
- dev_err(kdev, "could not attach to PHY\n");
- return PTR_ERR(phydev);
- }
-
- /* mask with MAC supported features */
- phy_support_sym_pause(phydev);
- phy_set_max_speed(phydev, SPEED_100);
- phy_set_sym_pause(phydev, priv->pause_rx, priv->pause_rx,
- priv->pause_auto);
-
- phy_attached_info(phydev);
-
+ /* Reset state */
priv->old_link = 0;
priv->old_duplex = -1;
priv->old_pause = -1;
- } else {
- phydev = NULL;
}
/* mask all interrupts and request them */
@@ -937,7 +914,7 @@ static int bcm_enet_open(struct net_devi
ret = request_irq(dev->irq, bcm_enet_isr_mac, 0, dev->name, dev);
if (ret)
- goto out_phy_disconnect;
+ return ret;
ret = request_irq(priv->irq_rx, bcm_enet_isr_dma, 0,
dev->name, dev);
@@ -1099,8 +1076,8 @@ static int bcm_enet_open(struct net_devi
enet_dmac_writel(priv, priv->dma_chan_int_mask,
ENETDMAC_IRMASK, priv->tx_chan);
- if (phydev)
- phy_start(phydev);
+ if (priv->has_phy)
+ phy_start(dev->phydev);
else
bcm_enet_adjust_link(dev);
@@ -1130,10 +1107,6 @@ out_freeirq_rx:
out_freeirq:
free_irq(dev->irq, dev);
-out_phy_disconnect:
- if (phydev)
- phy_disconnect(phydev);
-
return ret;
}
@@ -1226,10 +1199,6 @@ static int bcm_enet_stop(struct net_devi
free_irq(priv->irq_rx, dev);
free_irq(dev->irq, dev);
- /* release phy */
- if (priv->has_phy)
- phy_disconnect(dev->phydev);
-
/* reset BQL after forced tx reclaim to not kernel panic */
netdev_reset_queue(dev);
@@ -1797,14 +1766,47 @@ static int bcm_enet_probe(struct platfor
/* do minimal hardware init to be able to probe mii bus */
bcm_enet_hw_preinit(priv);
+ spin_lock_init(&priv->rx_lock);
+
+ /* init rx timeout (used for oom) */
+ timer_setup(&priv->rx_timeout, bcm_enet_refill_rx_timer, 0);
+
+ /* init the mib update lock&work */
+ mutex_init(&priv->mib_update_lock);
+ INIT_WORK(&priv->mib_update_task, bcm_enet_update_mib_counters_defer);
+
+ /* zero mib counters */
+ for (i = 0; i < ENET_MIB_REG_COUNT; i++)
+ enet_writel(priv, 0, ENET_MIB_REG(i));
+
+ /* register netdevice */
+ dev->netdev_ops = &bcm_enet_ops;
+ netif_napi_add(dev, &priv->napi, bcm_enet_poll, 16);
+
+ dev->ethtool_ops = &bcm_enet_ethtool_ops;
+ /* MTU range: 46 - 2028 */
+ dev->min_mtu = ETH_ZLEN - ETH_HLEN;
+ dev->max_mtu = BCMENET_MAX_MTU - VLAN_ETH_HLEN;
+ SET_NETDEV_DEV(dev, &pdev->dev);
+
+ ret = register_netdev(dev);
+ if (ret)
+ goto out_uninit_hw;
+
+ netif_carrier_off(dev);
+ platform_set_drvdata(pdev, dev);
+ priv->pdev = pdev;
+ priv->net_dev = dev;
/* MII bus registration */
if (priv->has_phy) {
+ struct phy_device *phydev;
+ char phy_id[MII_BUS_ID_SIZE + 3];
priv->mii_bus = mdiobus_alloc();
if (!priv->mii_bus) {
ret = -ENOMEM;
- goto out_uninit_hw;
+ goto out_unregister_netdev;
}
bus = priv->mii_bus;
@@ -1828,6 +1830,26 @@ static int bcm_enet_probe(struct platfor
dev_err(&pdev->dev, "unable to register mdio bus\n");
goto out_free_mdio;
}
+
+ /* connect to PHY */
+ snprintf(phy_id, sizeof(phy_id), PHY_ID_FMT,
+ priv->mii_bus->id, priv->phy_id);
+
+ phydev = phy_connect(dev, phy_id, bcm_enet_adjust_phy_link,
+ PHY_INTERFACE_MODE_MII);
+
+ if (IS_ERR(phydev)) {
+ dev_err(&pdev->dev, "could not attach to PHY\n");
+ goto out_unregister_mdio;
+ }
+
+ /* mask with MAC supported features */
+ phy_support_sym_pause(phydev);
+ phy_set_max_speed(phydev, SPEED_100);
+ phy_set_sym_pause(phydev, priv->pause_rx, priv->pause_rx,
+ priv->pause_auto);
+
+ phy_attached_info(phydev);
} else {
/* run platform code to initialize PHY device */
@@ -1835,45 +1857,16 @@ static int bcm_enet_probe(struct platfor
pd->mii_config(dev, 1, bcm_enet_mdio_read_mii,
bcm_enet_mdio_write_mii)) {
dev_err(&pdev->dev, "unable to configure mdio bus\n");
- goto out_uninit_hw;
+ goto out_unregister_netdev;
}
}
- spin_lock_init(&priv->rx_lock);
-
- /* init rx timeout (used for oom) */
- timer_setup(&priv->rx_timeout, bcm_enet_refill_rx_timer, 0);
-
- /* init the mib update lock&work */
- mutex_init(&priv->mib_update_lock);
- INIT_WORK(&priv->mib_update_task, bcm_enet_update_mib_counters_defer);
-
- /* zero mib counters */
- for (i = 0; i < ENET_MIB_REG_COUNT; i++)
- enet_writel(priv, 0, ENET_MIB_REG(i));
-
- /* register netdevice */
- dev->netdev_ops = &bcm_enet_ops;
- netif_napi_add(dev, &priv->napi, bcm_enet_poll, 16);
-
- dev->ethtool_ops = &bcm_enet_ethtool_ops;
- /* MTU range: 46 - 2028 */
- dev->min_mtu = ETH_ZLEN - ETH_HLEN;
- dev->max_mtu = BCMENET_MAX_MTU - VLAN_ETH_HLEN;
- SET_NETDEV_DEV(dev, &pdev->dev);
-
- ret = register_netdev(dev);
- if (ret)
- goto out_unregister_mdio;
-
- netif_carrier_off(dev);
- platform_set_drvdata(pdev, dev);
- priv->pdev = pdev;
- priv->net_dev = dev;
-
return 0;
out_unregister_mdio:
+ if (dev->phydev)
+ phy_disconnect(dev->phydev);
+
if (priv->mii_bus)
mdiobus_unregister(priv->mii_bus);
@@ -1881,6 +1874,9 @@ out_free_mdio:
if (priv->mii_bus)
mdiobus_free(priv->mii_bus);
+out_unregister_netdev:
+ unregister_netdev(dev);
+
out_uninit_hw:
/* turn off mdc clock */
enet_writel(priv, 0, ENET_MIISC_REG);
@@ -1911,6 +1907,7 @@ static int bcm_enet_remove(struct platfo
enet_writel(priv, 0, ENET_MIISC_REG);
if (priv->has_phy) {
+ phy_disconnect(dev->phydev);
mdiobus_unregister(priv->mii_bus);
mdiobus_free(priv->mii_bus);
} else {
|