diff options
Diffstat (limited to 'target')
4 files changed, 45 insertions, 10 deletions
diff --git a/target/linux/ipq40xx/base-files/etc/board.d/02_network b/target/linux/ipq40xx/base-files/etc/board.d/02_network index 46e6a3f9bd..e682a0fb15 100644 --- a/target/linux/ipq40xx/base-files/etc/board.d/02_network +++ b/target/linux/ipq40xx/base-files/etc/board.d/02_network @@ -163,9 +163,6 @@ ipq40xx_setup_macs() pakedge,wr-1) wan_mac=$(macaddr_add $(get_mac_label) 1) ;; - openmesh,a62) - label_mac="$(mtd_get_mac_binary "0:ART" 0x0)" - ;; esac [ -n "$lan_mac" ] && ucidef_set_interface_macaddr "lan" $lan_mac diff --git a/target/linux/ipq40xx/base-files/etc/hotplug.d/firmware/11-ath10k-caldata b/target/linux/ipq40xx/base-files/etc/hotplug.d/firmware/11-ath10k-caldata index 559aacea1e..9cdbaa3d4e 100644 --- a/target/linux/ipq40xx/base-files/etc/hotplug.d/firmware/11-ath10k-caldata +++ b/target/linux/ipq40xx/base-files/etc/hotplug.d/firmware/11-ath10k-caldata @@ -34,7 +34,6 @@ case "$FIRMWARE" in /usr/bin/fritz_cal_extract -i 1 -s 0x3C800 -e 0x212 -l 12064 -o /lib/firmware/$FIRMWARE $(find_mtd_chardev "urlader1") || \ /usr/bin/fritz_cal_extract -i 1 -s 0x3C000 -e 0x212 -l 12064 -o /lib/firmware/$FIRMWARE $(find_mtd_chardev "urlader1") ;; - openmesh,a62 |\ plasmacloud,pa2200) caldata_extract "0:ART" 0x9000 0x2f20 ;; @@ -77,7 +76,6 @@ case "$FIRMWARE" in /usr/bin/fritz_cal_extract -i 1 -s 0x3D000 -e 0x207 -l 12064 -o /lib/firmware/$FIRMWARE $(find_mtd_chardev "urlader1") ;; cellc,rtl30vw |\ - openmesh,a62 |\ plasmacloud,pa1200 |\ plasmacloud,pa2200) caldata_extract "0:ART" 0x1000 0x2f20 @@ -173,7 +171,6 @@ case "$FIRMWARE" in /usr/bin/fritz_cal_extract -i 1 -s 0x3C000 -e 0x208 -l 12064 -o /lib/firmware/$FIRMWARE $(find_mtd_chardev "urlader1") ;; cellc,rtl30vw |\ - openmesh,a62 |\ plasmacloud,pa1200 |\ plasmacloud,pa2200) caldata_extract "0:ART" 0x5000 0x2f20 diff --git a/target/linux/ipq40xx/base-files/lib/preinit/05_set_iface_mac_ipq40xx.sh b/target/linux/ipq40xx/base-files/lib/preinit/05_set_iface_mac_ipq40xx.sh index 81d22686a3..ddfef1ab2d 100644 --- a/target/linux/ipq40xx/base-files/lib/preinit/05_set_iface_mac_ipq40xx.sh +++ b/target/linux/ipq40xx/base-files/lib/preinit/05_set_iface_mac_ipq40xx.sh @@ -29,10 +29,6 @@ preinit_set_mac_address() { ip link set dev lan1 address $(macaddr_add "$base_mac" 1) ip link set dev eth0 address $(macaddr_setbit "$base_mac" 7) ;; - openmesh,a62) - ip link set dev ethernet1 address $(mtd_get_mac_binary "0:ART" 0x0) - ip link set dev ethernet2 address $(mtd_get_mac_binary "0:ART" 0x6) - ;; mikrotik,wap-ac) base_mac=$(cat /sys/firmware/mikrotik/hard_config/mac_base) ip link set dev sw-eth1 address "$base_mac" diff --git a/target/linux/ipq40xx/files/arch/arm/boot/dts/qcom-ipq4019-a62.dts b/target/linux/ipq40xx/files/arch/arm/boot/dts/qcom-ipq4019-a62.dts index 11d27ab339..d348101110 100644 --- a/target/linux/ipq40xx/files/arch/arm/boot/dts/qcom-ipq4019-a62.dts +++ b/target/linux/ipq40xx/files/arch/arm/boot/dts/qcom-ipq4019-a62.dts @@ -71,6 +71,7 @@ led-failsafe = &led_status_green; led-running = &led_status_green; led-upgrade = &led_status_green; + label-mac-device = &swport4; }; leds { @@ -151,7 +152,36 @@ compatible = "jedec,spi-nor"; reg = <0>; spi-max-frequency = <24000000>; + /* partitions are passed via bootloader */ + partitions { + partition-art { + compatible = "nvmem-cells"; + #address-cells = <1>; + #size-cells = <1>; + label = "0:ART"; + + precal_art_1000: precal@1000 { + reg = <0x1000 0x2f20>; + }; + + precal_art_5000: precal@5000 { + reg = <0x5000 0x2f20>; + }; + + precal_art_9000: precal@9000 { + reg = <0x9000 0x2f20>; + }; + + macaddr_gmac0: macaddr@0 { + reg = <0x0 0x6>; + }; + + macaddr_gmac1: macaddr@6 { + reg = <0x6 0x6>; + }; + }; + }; }; }; @@ -186,6 +216,9 @@ reg = <0x00010000 0 0 0 0>; qcom,ath10k-calibration-variant = "OM-A62"; ieee80211-freq-limit = <5170000 5350000>; + + nvmem-cell-names = "pre-calibration"; + nvmem-cells = <&precal_art_9000>; }; }; }; @@ -205,20 +238,32 @@ &swport4 { status = "okay"; label = "ethernet1"; + + nvmem-cell-names = "mac-address"; + nvmem-cells = <&macaddr_gmac0>; }; &swport5 { status = "okay"; label = "ethernet2"; + + nvmem-cell-names = "mac-address"; + nvmem-cells = <&macaddr_gmac1>; }; &wifi0 { status = "okay"; qcom,ath10k-calibration-variant = "OM-A62"; + + nvmem-cell-names = "pre-calibration"; + nvmem-cells = <&precal_art_1000>; }; &wifi1 { status = "okay"; qcom,ath10k-calibration-variant = "OM-A62"; ieee80211-freq-limit = <5470000 5875000>; + + nvmem-cell-names = "pre-calibration"; + nvmem-cells = <&precal_art_5000>; }; |