ath79: fix LEDs for GL.inet GL-AR150

Since the wireless LED was used for boot and set up with a DT
trigger, the WiFi indication hasn't worked on ath79 at all.

In addition, a look into the manual revealed that the OEM
configuration is as follows:

LED 1 (green): power
LED 2 (green): configurable
LED 3 (red): wireless

So, let's just keep the WiFi trigger and convert the rest to its
"intended" use.

Signed-off-by: Adrian Schmutzler <freifunk@adrianschmutzler.de>

1 files changed, 10 insertions, 8 deletions

diff --git a/target/linux/ath79/dts/ar9330_glinet_gl-ar150.dts b/target/linux/ath79/dts/ar9330_glinet_gl-ar150.dts
index 68e1995c76..d81d477227 100644
--- a/target/linux/ath79/dts/ar9330_glinet_gl-ar150.dts
+++ b/target/linux/ath79/dts/ar9330_glinet_gl-ar150.dts
@@ -12,29 +12,31 @@
 
 	aliases {
 		serial0 = &uart;
-		led-boot = &led_wlan;
-		led-failsafe = &led_wlan;
-		led-upgrade = &led_wlan;
+		led-boot = &led_power;
+		led-failsafe = &led_power;
+		led-running = &led_power;
+		led-upgrade = &led_power;
 		label-mac-device = &eth0;
 	};
 
 	leds {
 		compatible = "gpio-leds";
 
-		led_wlan: wlan {
+		wlan {
 			label = "gl-ar150:orange:wlan";
 			gpios = <&gpio 0 GPIO_ACTIVE_HIGH>;
 			linux,default-trigger = "phy0tpt";
 		};
 
-		lan {
-			label = "gl-ar150:green:lan";
+		configurable {
+			label = "gl-ar150:green:configurable";
 			gpios = <&gpio 13 GPIO_ACTIVE_HIGH>;
 		};
 
-		wan {
-			label = "gl-ar150:green:wan";
+		led_power: power {
+			label = "gl-ar150:green:power";
 			gpios = <&gpio 15 GPIO_ACTIVE_HIGH>;
+			default-state = "on";
 		};
 	};