1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
|
Document the optional parameters needed for PWM operation of gpio
lines.
Signed-off-by: Andrew Lunn <andrew@lunn.ch>
---
.../devicetree/bindings/gpio/gpio-mvebu.txt | 31 ++++++++++++++++++++++
1 file changed, 31 insertions(+)
--- a/Documentation/devicetree/bindings/gpio/gpio-mvebu.txt
+++ b/Documentation/devicetree/bindings/gpio/gpio-mvebu.txt
@@ -38,6 +38,23 @@ Required properties:
- #gpio-cells: Should be two. The first cell is the pin number. The
second cell is reserved for flags, unused at the moment.
+Optional properties:
+
+In order to use the gpio lines in PWM mode, some additional optional
+properties are required. Only Armada 370 and XP supports these
+properties.
+
+- reg: an additional register set is needed, for the GPIO Blink
+ Counter on/off registers.
+
+- reg-names: Must contain an entry "pwm" corresponding to the
+ additional register range needed for pwm operation.
+
+- #pwm-cells: Should be two. The first cell is the pin number. The
+ second cell is reserved for flags, unused at the moment.
+
+- clocks: Must be a phandle to the clock for the gpio controller.
+
Example:
gpio0: gpio@d0018100 {
@@ -51,3 +68,17 @@ Example:
#interrupt-cells = <2>;
interrupts = <16>, <17>, <18>, <19>;
};
+
+ gpio1: gpio@18140 {
+ compatible = "marvell,orion-gpio";
+ reg = <0x18140 0x40>, <0x181c8 0x08>;
+ reg-names = "gpio", "pwm";
+ ngpios = <17>;
+ gpio-controller;
+ #gpio-cells = <2>;
+ #pwm-cells = <2>;
+ interrupt-controller;
+ #interrupt-cells = <2>;
+ interrupts = <87>, <88>, <89>;
+ clocks = <&coreclk 0>;
+ };
|
