1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
|
/*
* This board file is used for the following setup:
* An ILI9488 display controller connected to an STM32F446VET micro controller through a 16-bit
* parallel interface (Intel 8080 compatible). The FMC interface of the STM32 micro controller is used.
* LCD_CS is hooked up to NE1 (first SRAM bank) and LCD_RS is hooked up to A16.
*/
#ifndef _GDISP_LLD_BOARD_H
#define _GDISP_LLD_BOARD_H
#include "stm32f4xx_hal.h"
#define GDISP_REG (*((volatile gU16 *) 0x60000000)) /* RS = 0 */
#define GDISP_RAM (*((volatile gU16 *) 0x60020000)) /* RS = 1 */
static GFXINLINE void init_board(GDisplay *g)
{
GPIO_InitTypeDef GPIO_InitStruct;
SRAM_HandleTypeDef hsram;
FMC_NORSRAM_TimingTypeDef Timing;
(void)g;
// Peripheral clocks
__HAL_RCC_GPIOC_CLK_ENABLE();
__HAL_RCC_GPIOD_CLK_ENABLE();
__HAL_RCC_FMC_CLK_ENABLE();
// PC6 (backlight)
GPIO_InitStruct.Pin = GPIO_PIN_6;
GPIO_InitStruct.Mode = GPIO_MODE_OUTPUT_PP;
GPIO_InitStruct.Pull = GPIO_NOPULL;
GPIO_InitStruct.Speed = GPIO_SPEED_HIGH;
HAL_GPIO_Init(GPIOC, &GPIO_InitStruct);
// PD3 (reset)
GPIO_InitStruct.Pin = GPIO_PIN_3;
GPIO_InitStruct.Mode = GPIO_MODE_OUTPUT_PP;
GPIO_InitStruct.Pull = GPIO_NOPULL;
GPIO_InitStruct.Speed = GPIO_SPEED_HIGH;
HAL_GPIO_Init(GPIOD, &GPIO_InitStruct);
// FSMC
{
// Common GPIO configuration
GPIO_InitStruct.Mode = GPIO_MODE_AF_PP;
GPIO_InitStruct.Pull = GPIO_PULLUP;
GPIO_InitStruct.Speed = GPIO_SPEED_HIGH;
GPIO_InitStruct.Alternate = GPIO_AF12_FMC;
// GPIOD configuration
GPIO_InitStruct.Pin = GPIO_PIN_0 | GPIO_PIN_1 | GPIO_PIN_4 | GPIO_PIN_5 | GPIO_PIN_7 | GPIO_PIN_8 |\
GPIO_PIN_9 | GPIO_PIN_10 | GPIO_PIN_11 | GPIO_PIN_14 | GPIO_PIN_15;
HAL_GPIO_Init(GPIOD, &GPIO_InitStruct);
// GPIOE configuration
GPIO_InitStruct.Pin = GPIO_PIN_7 | GPIO_PIN_8 | GPIO_PIN_9 | GPIO_PIN_10 | GPIO_PIN_11 |\
GPIO_PIN_12 | GPIO_PIN_13 | GPIO_PIN_14 | GPIO_PIN_15;
HAL_GPIO_Init(GPIOE, &GPIO_InitStruct);
// SRAM device configuration
hsram.Instance = FMC_NORSRAM_DEVICE;
hsram.Extended = FMC_NORSRAM_EXTENDED_DEVICE;
// hsram.Init
hsram.Init.NSBank = FMC_NORSRAM_BANK1;
hsram.Init.DataAddressMux = FMC_DATA_ADDRESS_MUX_DISABLE;
hsram.Init.MemoryType = FMC_MEMORY_TYPE_SRAM;
hsram.Init.MemoryDataWidth = FMC_NORSRAM_MEM_BUS_WIDTH_16;
hsram.Init.BurstAccessMode = FMC_BURST_ACCESS_MODE_DISABLE;
hsram.Init.WaitSignalPolarity = FMC_WAIT_SIGNAL_POLARITY_LOW;
hsram.Init.WaitSignalActive = FMC_WAIT_TIMING_BEFORE_WS;
hsram.Init.WriteOperation = FMC_WRITE_OPERATION_ENABLE;
hsram.Init.WaitSignal = FMC_WAIT_SIGNAL_DISABLE;
hsram.Init.ExtendedMode = FMC_EXTENDED_MODE_DISABLE;
hsram.Init.AsynchronousWait = FMC_ASYNCHRONOUS_WAIT_DISABLE;
hsram.Init.WriteBurst = FMC_WRITE_BURST_DISABLE;
hsram.Init.ContinuousClock = FMC_CONTINUOUS_CLOCK_SYNC_ONLY;
hsram.Init.WriteFifo = FMC_WRITE_FIFO_ENABLE;
hsram.Init.PageSize = FMC_PAGE_SIZE_NONE;
// Timings
Timing.AddressSetupTime = 0;
Timing.AddressHoldTime = 0;
Timing.DataSetupTime = 150;
Timing.BusTurnAroundDuration = 0;
Timing.CLKDivision = 0;
Timing.DataLatency = 0;
Timing.AccessMode = FMC_ACCESS_MODE_A;
HAL_SRAM_Init(&hsram, &Timing, NULL);
}
}
static GFXINLINE void post_init_board(GDisplay* g)
{
(void) g;
}
static GFXINLINE void setpin_reset(GDisplay *g, gBool state)
{
(void) g;
if (state) {
HAL_GPIO_WritePin(GPIOD, GPIO_PIN_3, GPIO_PIN_SET);
} else {
HAL_GPIO_WritePin(GPIOD, GPIO_PIN_3, GPIO_PIN_RESET);
}
}
static GFXINLINE void set_backlight(GDisplay* g, gU8 percent)
{
(void) g;
if (percent > 0) {
HAL_GPIO_WritePin(GPIOC, GPIO_PIN_6, GPIO_PIN_SET);
} else {
HAL_GPIO_WritePin(GPIOC, GPIO_PIN_6, GPIO_PIN_RESET);
}
}
static GFXINLINE void acquire_bus(GDisplay* g)
{
(void) g;
}
static GFXINLINE void release_bus(GDisplay* g)
{
(void) g;
}
static GFXINLINE void write_index(GDisplay* g, gU16 index)
{
(void) g;
GDISP_REG = index;
}
static GFXINLINE void write_data(GDisplay* g, gU16 data)
{
(void) g;
GDISP_RAM = data;
}
static GFXINLINE void setreadmode(GDisplay* g)
{
(void) g;
}
static GFXINLINE void setwritemode(GDisplay* g)
{
(void) g;
}
static GFXINLINE gU16 read_data(GDisplay* g)
{
(void) g;
return (gU16)GDISP_RAM;
}
#endif /* _GDISP_LLD_BOARD_H */
|
