diff options
Diffstat (limited to 'drivers/gdisp/ST7565/gdisp_lld_board_template.h')
-rw-r--r-- | drivers/gdisp/ST7565/gdisp_lld_board_template.h | 82 |
1 files changed, 0 insertions, 82 deletions
diff --git a/drivers/gdisp/ST7565/gdisp_lld_board_template.h b/drivers/gdisp/ST7565/gdisp_lld_board_template.h deleted file mode 100644 index 2f40ccc7..00000000 --- a/drivers/gdisp/ST7565/gdisp_lld_board_template.h +++ /dev/null @@ -1,82 +0,0 @@ -/* - * This file is subject to the terms of the GFX License. If a copy of - * the license was not distributed with this file, you can obtain one at: - * - * http://ugfx.org/license.html - */ - -#ifndef _GDISP_LLD_BOARD_H -#define _GDISP_LLD_BOARD_H - -/** - * @brief Initialize the board for the display. - * @notes This board definition uses GPIO and assumes exclusive access to these GPIO pins - * @notapi - */ -static inline void init_board(void) { - /* Configure SPI bus here. Up to 10Mhz, SPI Mode = 3 (CPOL = 1, CPHA = 0) */ - /* Configure A0, !CS, !RST pin for output */ -} - -/** - * @brief Set or clear the lcd reset pin. - * @param[in] state TRUE = lcd in reset, FALSE = normal operation - * @notapi - */ -static inline void setpin_reset(bool_t state) { - /* Set !CS to low */ - if (state) { - /* Set !RST to low */ - } else { - /* Set !RST to high */ - } -} - -/** - * @brief Set the lcd back-light level. - * @param[in] percent 0 to 100% - * @notapi - */ -static inline void set_backlight(uint8_t percent) { - -} - -/** - * @brief Take exclusive control of the bus - * @notapi - */ -static inline void acquire_bus(void) { - -} - -/** - * @brief Release exclusive control of the bus - * @notapi - */ -static inline void release_bus(void) { - -} - -/** - * @brief Send command to the display. - * @param[in] cmd The command to send - * @notapi - */ -static inline void write_cmd(uint8_t cmd) { - /* Set A0 to low */ - /* Transmit cmd over SPI */ -} - -/** - * @brief Send data to the display. - * @param[in] data The data to send - * @notapi - */ -static inline void write_data(uint8_t* data, uint16_t length) { - /* Set A0 to high */ - /* Transmit data for length over SPI. DMA is recommended. */ -} - -#endif /* _GDISP_LLD_BOARD_H */ -/** @} */ - |