aboutsummaryrefslogtreecommitdiffstats
path: root/drivers/gdisp/ST7565/gdisp_lld_board_template.h
diff options
context:
space:
mode:
Diffstat (limited to 'drivers/gdisp/ST7565/gdisp_lld_board_template.h')
-rw-r--r--drivers/gdisp/ST7565/gdisp_lld_board_template.h82
1 files changed, 82 insertions, 0 deletions
diff --git a/drivers/gdisp/ST7565/gdisp_lld_board_template.h b/drivers/gdisp/ST7565/gdisp_lld_board_template.h
new file mode 100644
index 00000000..2f40ccc7
--- /dev/null
+++ b/drivers/gdisp/ST7565/gdisp_lld_board_template.h
@@ -0,0 +1,82 @@
+/*
+ * This file is subject to the terms of the GFX License. If a copy of
+ * the license was not distributed with this file, you can obtain one at:
+ *
+ * http://ugfx.org/license.html
+ */
+
+#ifndef _GDISP_LLD_BOARD_H
+#define _GDISP_LLD_BOARD_H
+
+/**
+ * @brief Initialize the board for the display.
+ * @notes This board definition uses GPIO and assumes exclusive access to these GPIO pins
+ * @notapi
+ */
+static inline void init_board(void) {
+ /* Configure SPI bus here. Up to 10Mhz, SPI Mode = 3 (CPOL = 1, CPHA = 0) */
+ /* Configure A0, !CS, !RST pin for output */
+}
+
+/**
+ * @brief Set or clear the lcd reset pin.
+ * @param[in] state TRUE = lcd in reset, FALSE = normal operation
+ * @notapi
+ */
+static inline void setpin_reset(bool_t state) {
+ /* Set !CS to low */
+ if (state) {
+ /* Set !RST to low */
+ } else {
+ /* Set !RST to high */
+ }
+}
+
+/**
+ * @brief Set the lcd back-light level.
+ * @param[in] percent 0 to 100%
+ * @notapi
+ */
+static inline void set_backlight(uint8_t percent) {
+
+}
+
+/**
+ * @brief Take exclusive control of the bus
+ * @notapi
+ */
+static inline void acquire_bus(void) {
+
+}
+
+/**
+ * @brief Release exclusive control of the bus
+ * @notapi
+ */
+static inline void release_bus(void) {
+
+}
+
+/**
+ * @brief Send command to the display.
+ * @param[in] cmd The command to send
+ * @notapi
+ */
+static inline void write_cmd(uint8_t cmd) {
+ /* Set A0 to low */
+ /* Transmit cmd over SPI */
+}
+
+/**
+ * @brief Send data to the display.
+ * @param[in] data The data to send
+ * @notapi
+ */
+static inline void write_data(uint8_t* data, uint16_t length) {
+ /* Set A0 to high */
+ /* Transmit data for length over SPI. DMA is recommended. */
+}
+
+#endif /* _GDISP_LLD_BOARD_H */
+/** @} */
+