aboutsummaryrefslogtreecommitdiffstats
path: root/Projects
Commit message (Collapse)AuthorAgeFilesLines
* Added new VTARGET_REF_VOLTS and VTARGET_SCALE_FACTOR compile time defines to ↵Dean Camera2010-05-277-11/+30
| | | | | | the AVRISP-MKII programmer project to set the VTARGET reference voltage and scale factor. Fixed XPLAINBridge project not correctly reading the XMEGA's supply voltage when reporting back to the host.
* Replace ring buffer library in Benito and USBtoSerial projects with the new ↵Dean Camera2010-05-2614-493/+203
| | | | lightweight ring buffer header to improve reliability.
* The EEPROM stream read/write functions now use eeprom_update_byte() instead ↵Dean Camera2010-05-262-4/+12
| | | | | | of eeprom_write_byte(), so that only changed bytes are written to EEPROM to preserve its lifespan. Changed over the AVRISP-MKII and TemperatureDataLogger projects to use eeprom_update_byte() when writing non-volatile parameters to EEPROM to preserve its lifespan.
* Add better documentation to the Software UART code in the XPLAINBridge project.Dean Camera2010-05-261-35/+71
|
* Switch software UART over to timer 1 and remove timer prescaling to try to ↵Dean Camera2010-05-263-17/+17
| | | | prevent integer rounding errors and thus minimize the possible error of the UART code.
* Rename software USART driver globals to make the code more in line with the ↵Dean Camera2010-05-263-12/+12
| | | | rest of the XPLAINBridge project.
* Make software USART used in the XPLAINBridge project directly check and ↵Dean Camera2010-05-265-68/+42
| | | | store into the ring buffers, rather than polling from the main program loop to avoid added latency.
* Create a new LightweightRingBuffer.h header file for the XPLAIN project to ↵Dean Camera2010-05-263-38/+101
| | | | abstract out the new ring buffer without a performance penalty.
* The RingBuff library code has been replaced in the XPLAINBridge project with ↵Dean Camera2010-05-268-281/+66
| | | | an ultra lightweight buffer to help improve the reliability of the bridge.
* Remove obsolete entry from the Doxygen configuration files.Dean Camera2010-05-2310-10/+10
|
* Short UUIDs are measured in bytes, not bits -- update Service Discovery ↵Dean Camera2010-05-201-4/+6
| | | | Protocol code so that it can now correctly match against UUIDs in the service table.
* Renamed CDC device class demos' ManagementEndpoint descriptor to ↵Dean Camera2010-05-208-8/+8
| | | | NotificationEndpoint to more accurately indicate its purpose.
* Begin processing code for Service Discovery Protocol attributes.Dean Camera2010-05-171-0/+1
|
* Fixed AVRISP project not sending a full erase-and-write EEPROM command to ↵Dean Camera2010-05-161-1/+1
| | | | XMEGA targets when writing to the EEPROM instead of the split write-only command (thanks to Tim Margush).
* Fixed AVRISP project sending a LOAD EXTENDED ADDRESS command to 128KB AVRs ↵Dean Camera2010-05-144-44/+39
| | | | after programming or reading from the last page of FLASH.
* Remove incorrect check for the current device state in the Set Configuration ↵Dean Camera2010-05-132-24/+26
| | | | | | request handler of DevChapter9, which broke Set Configuration requests to the device under most circumstances. Move out the SPI prescaler list to a PROGMEM module-level variable in ISPTarget.c.
* Additional fix to the AVRISP-MKII clone project for 256KB AVRs.Dean Camera2010-05-131-18/+14
|
* Fixed AVRISP-MKII clone project not correctly issuing SET EXTENDED ADDRESS ↵Dean Camera2010-05-136-14/+42
| | | | | | commands when the extended address boundary is crossed during programming or readback (thanks to Gerard Sexton). Fixed warnings when building the AVRISP-MKII clone project with the ENABLE_XPROG_PROTOCOL compile time option disabled.
* The LIBUSB_FILTERDRV_COMPAT compile time option in the XPLAINBridge and ↵Dean Camera2010-05-139-15/+12
| | | | | | AVRISP-MKII projects has been renamed LIBUSB_DRIVER_COMPAT, as it applies to all software on all platforms using the libUSB driver. Fix Benito makefile which was accidentally changed during testing.
* Removed TeensyHID bootloader, per request from Paul at PJRC.Dean Camera2010-05-121-3/+3
|
* Add new ReportType parameter to the HID class driver device callback and ↵Dean Camera2010-05-095-11/+6
| | | | | | host report sending routines. Renamed internal Host mode Class driver descriptor comparator callback routines so that they all start with a uniform DCOMP_{Class Abbreviation}_ prefix.
* Add svn:eol-style property to source files, so that the line endings are ↵Dean Camera2010-05-08202-61036/+61036
| | | | correctly converted to the target system's native end of line style.
* Change over instances of "make" in the makefiles to "$(MAKE)" to allow for ↵Dean Camera2010-05-0713-42/+42
| | | | the make tool to be overridden.
* Don't cast the line encoding baud rate to a uint16_t before performing the ↵Dean Camera2010-05-071-1/+1
| | | | baud rate calculation in the Benito project.
* Change over unix line-endings to dos line endings.Dean Camera2010-05-0715-6712/+6712
|
* Remove incorrect Abstract Call Management class specific descriptor from the ↵Dean Camera2010-05-068-36/+0
| | | | CDC demos, bootloaders and projects.
* Removed software PDI/TPI emulation from the AVRISP-MKII clone project, as it ↵Dean Camera2010-05-043-293/+8
| | | | was very buggy. PDI and TPI must now be implemented via seperate headers instead of the one unified ISP/TPI/PDI header.
* Fixed device state not being reset back to the default state if the host ↵Dean Camera2010-05-041-2/+3
| | | | | | | | sets the address to 0x00. Fixed Set Configuration requests not being stalled until the host has set the device's address. Fixed possibility of internal signature retrieval being corrupted if an interrupt occurs during a signature byte read (thanks to Andrei Krainev).
* Added new ENDPOINT_*_BusSuspended error code to the Endpoint function, so ↵Dean Camera2010-05-031-2/+2
| | | | that the stream functions early-abort if the bus is suspended before or during a transfer.
* Increase hardware PDI/TPI programming speed to 1MHz in the AVRISP MKII clone ↵Dean Camera2010-05-023-3/+4
| | | | project.
* Switch back to C based timeout ISR in the AVRISP project - assembly version ↵Dean Camera2010-05-024-25/+21
| | | | was failing, and only one or two cycles could be shaved off the compiler generated code.
* Change AVRISP project's timeout to be interrupt based again, but make the ↵Dean Camera2010-05-029-116/+63
| | | | | | interrupt itself interruptable and use a seperate assembly file to hand-optimize the ISR code. Removed the cast to uint16_t on the set baud rate in the USBtoSerial project, so that the higher >1M baud rates can be selected (thanks to Steffan).
* Make sure that long reads are aborted early if the connection times out ↵Dean Camera2010-04-303-5/+8
| | | | while waiting on more bytes in the AVRISP MKII clone project.
* Make sure that the NVM bus/controller busy waits in the AVRISP MKII clone ↵Dean Camera2010-04-303-15/+54
| | | | project abort properly if a timeout occurs while waiting for a response.
* Relocate USBInterrupt.c/.h from the HighLevel USB driver directory to the ↵Dean Camera2010-04-2812-24/+24
| | | | LowLevel directory as it is hardware-dependent.
* USB_Init() no longer calls sei() to enable global interrupts - this must now ↵Dean Camera2010-04-2820-6/+30
| | | | be done in the user application once all init code has run.
* Make AVRISP-MKII clone project's software PDI/TPI mode more robust by ↵Dean Camera2010-04-281-14/+25
| | | | keeping track of timeouts while waiting for a Tx/Rx to finish.
* Added ability to search by Channel PSM to the GetChannelData() function in ↵Dean Camera2010-04-221-1/+1
| | | | | | | | | | the BluetoothHost demo. Added new HCI states to properly initialize the bluetooth dongle and retrieve the local BDADDR. Factored out Bluetooth state information into a new state structure for easy reference in the user application. Added new StackInitialized() Bluetooth stack callback function.
* Add const keyword to the demo function parameters where possible.Dean Camera2010-04-1821-60/+60
|
* Fixed Set/Clear Feature requests directed to a non-configured endpoint not ↵Dean Camera2010-04-141-1/+1
| | | | | | returning a stall to the host. Make TeensyHID bootloader use an 8 byte control endpoint to match the official Teensy, just in case Paul decides to authenticate on that attribute in the future.
* Document the Bluetooth ACL layer. Remove unneeded parameters from the ↵Dean Camera2010-04-131-1/+1
| | | | | | | | signalling command processing routines. Change over the code so that the bluetooth packet data is read in by the stack rather than the user application, to make it more unform for sending/receiving, and so the library can handle incomming fragmentation in the future. Start Service Discovery Protocol decoding and processing.
* Add information request/response signal handler to the Bluetooth Host demo.Dean Camera2010-04-065-5/+5
| | | | Ensure that the AVRISP-MKII project's Windows avrdude compatibility define is named properly in all parts of the code.
* Add user callback function to the Bluetooth host demo to filter out ↵Dean Camera2010-04-053-17/+25
| | | | | | | | connections from remote devices. Add in ability to reject connections based on their bluetooth device address. Clean up RelayBoard project code. Make AVRISP project clear the XMEGA target's reset register twice; this does not appear to take affect properly the first time under some circumstances.
* More improvements to the incomplete BluetoothHost demo - add Disconnection ↵Dean Camera2010-04-011-3/+0
| | | | | | Event processing. Remove unused macro in the host mode demos for the maximum Configuration Descriptor size.
* Added WIN_LIBUSB_COMPAT compile time option to the AVRISP programmer project ↵Dean Camera2010-03-3114-17/+100
| | | | to make the code compatible with Windows builds of avrdude at the expense of AVRStudio compatibility.
* Add RelayBoard project patch from OBinou.Dean Camera2010-03-311-10/+10
|
* Added board hardware driver support for the Benito programmer.Dean Camera2010-03-302-111/+1
|
* Add briefs for the library core structures.Dean Camera2010-03-292-5/+1
|
* All Class Driver Host mode demos now correctly set the board LEDs to READY ↵Dean Camera2010-03-254-1/+4
| | | | | | once the enumeration process has completed. Fixed Still Image Host class driver not resetting the transaction ID when a new session is opened, fixed driver not sending a valid session ID to the device.
* Added new Relay Controller Board project (thanks to OBinou).Dean Camera2010-03-248-0/+2861
| | | | Added hardware board driver support for the PJRC Teensy line of USB AVR boards.
generated by cgit v1.2.3 (git 2.25.1) at 2024-10-09 19:31:27 +0000