blob: 8e8775c27f8e93a27e134c2d8e9e6dfeb5baf8c0 (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
|
/*
* Licensed under ST Liberty SW License Agreement V2, (the "License");
* You may not use this file except in compliance with the License.
* You may obtain a copy of the License at:
*
* http://www.st.com/software_license_agreement_liberty_v2
*
* Unless required by applicable law or agreed to in writing, software
* distributed under the License is distributed on an "AS IS" BASIS,
* WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
* See the License for the specific language governing permissions and
* limitations under the License.
*/
/*
* SPC560Pxx drivers configuration.
* The following settings override the default settings present in
* the various device driver implementation headers.
* Note that the settings for each driver only have effect if the whole
* driver is enabled in halconf.h.
*
* IRQ priorities:
* 1...15 Lowest...Highest.
*/
#define SPC563Mxx_MCUCONF
/*
* HAL driver system settings.
*/
#define SPC5_NO_INIT FALSE
#define SPC5_CLK_BYPASS FALSE
#define SPC5_ALLOW_OVERCLOCK FALSE
#define SPC5_CLK_PREDIV_VALUE 2
#define SPC5_CLK_MFD_VALUE 80
#define SPC5_CLK_RFD SPC5_RFD_DIV4
#define SPC5_FLASH_BIUCR (BIUCR_BANK1_TOO | \
BIUCR_MASTER4_PREFETCH | \
BIUCR_MASTER0_PREFETCH | \
BIUCR_DPFEN | \
BIUCR_IPFEN | \
BIUCR_PFLIM_ON_MISS | \
BIUCR_BFEN)
/*
* SERIAL driver system settings.
*/
#define SPC5_USE_ESCIA TRUE
#define SPC5_USE_ESCIB TRUE
#define SPC5_ESCIA_PRIORITY 8
#define SPC5_ESCIB_PRIORITY 8
|
