1 files changed, 0 insertions, 99 deletions
diff --git a/os/hal/platforms/STM8L/platform.dox b/os/hal/platforms/STM8L/platform.dox
deleted file mode 100644
index 9c28a931b..000000000
--- a/os/hal/platforms/STM8L/platform.dox
+++ /dev/null
@@ -1,99 +0,0 @@
-/*
-    ChibiOS/RT - Copyright (C) 2006-2013 Giovanni Di Sirio
-
-    Licensed under the Apache License, Version 2.0 (the "License");
-    you may not use this file except in compliance with the License.
-    You may obtain a copy of the License at
-
-        http://www.apache.org/licenses/LICENSE-2.0
-
-    Unless required by applicable law or agreed to in writing, software
-    distributed under the License is distributed on an "AS IS" BASIS,
-    WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
-    See the License for the specific language governing permissions and
-    limitations under the License.
-*/
-
-/**
- * @defgroup STM8L_DRIVERS STM8L Drivers
- * @details This section describes all the supported drivers on the STM8L
- * and the implementation details of the single drivers.
- *
- * @ingroup platforms
- */
-
-/**
- * @defgroup STM8L_HAL STM8L Initialization Support
- * @details The STM8L HAL support is responsible for system initialization.
- *
- * @section stm8l_hal_1 Supported HW resources
- * - CLK.
- * .
- * @section stm8l_hal_2 STM8L HAL driver implementation features
- * - Board related initializations.
- * - Clock tree initialization.
- * - Clock source selection.
- * .
- * @ingroup STM8L_DRIVERS
- */
-
-/**
- * @defgroup STM8L_PAL STM8L PAL Support
- * @details The STM8L PAL driver uses the GPIO peripherals.
- *
- * @section stm8l_pal_1 Supported HW resources
- * - GPIOA.
- * - GPIOB.
- * - GPIOC.
- * - GPIOD.
- * - GPIOE.
- * - GPIOF.
- * - GPIOG.
- * - GPIOH (where present).
- * - GPIOI (where present).
- * .
- * @section stm8l_pal_2 STM8L PAL driver implementation features
- * The PAL driver implementation fully supports the following hardware
- * capabilities:
- * - 8 bits wide ports.
- * - Atomic set/reset/toggle functions because special STM8L instruction set.
- * - Output latched regardless of the pad setting.
- * - Direct read of input pads regardless of the pad setting.
- * .
- * @section stm8l_pal_3 Supported PAL setup modes
- * The STM8L PAL driver supports the following I/O modes:
- * - @p PAL_MODE_RESET.
- * - @p PAL_MODE_UNCONNECTED.
- * - @p PAL_MODE_INPUT.
- * - @p PAL_MODE_INPUT_PULLUP.
- * - @p PAL_MODE_OUTPUT_PUSHPULL.
- * - @p PAL_MODE_OUTPUT_OPENDRAIN.
- * .
- * Any attempt to setup an invalid mode is ignored.
- *
- * @section stm8l_pal_4 Suboptimal behavior
- * The STM8L GPIO is less than optimal in several areas, the limitations
- * should be taken in account while using the PAL driver:
- * - Bus/group writing is not atomic.
- * - Pad/group mode setup is not atomic.
- * .
- * @ingroup STM8L_DRIVERS
- */
-
-/**
- * @defgroup STM8L_SERIAL STM8L Serial Support
- * @details The STM8L Serial driver uses the USART1 peripheral in a
- *          buffered, interrupt driven, implementation.
- *
- * @section stm8l_serial_1 Supported HW resources
- * The serial driver can support any of the following hardware resources:
- * - USART1.
- * - USART2 (where present).
- * - USART3 (where present).
- * .
- * @section stm8l_serial_2 STM8L Serial driver implementation features
- * - Clock stop for reduced power usage when the driver is in stop state.
- * - Fully interrupt driven.
- * .
- * @ingroup STM8L_DRIVERS
- */