1 files changed, 0 insertions, 118 deletions
diff --git a/os/hal/platforms/LPC214x/platform.dox b/os/hal/platforms/LPC214x/platform.dox
deleted file mode 100644
index e5189558a..000000000
--- a/os/hal/platforms/LPC214x/platform.dox
+++ /dev/null
@@ -1,118 +0,0 @@
-/*
-    ChibiOS/RT - Copyright (C) 2006-2013 Giovanni Di Sirio
-
-    Licensed under the Apache License, Version 2.0 (the "License");
-    you may not use this file except in compliance with the License.
-    You may obtain a copy of the License at
-
-        http://www.apache.org/licenses/LICENSE-2.0
-
-    Unless required by applicable law or agreed to in writing, software
-    distributed under the License is distributed on an "AS IS" BASIS,
-    WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
-    See the License for the specific language governing permissions and
-    limitations under the License.
-*/
-
-/**
- * @defgroup LPC214x LPC214x Drivers
- * @details This section describes all the supported drivers on the LPC214x
- *          platform and the implementation details of the single drivers.
- *
- * @ingroup platforms
- */
-
-/**
- * @defgroup LPC214x_HAL LPC214x Initialization Support
- * @details The LPC214x HAL support is responsible for system initialization.
- *
- * @section lpc214x_hal_1 Supported HW resources
- * - PLL0.
- * - MAM.
- * - VPBDIV.
- * .
- * @section lpc214x_hal_2 LPC214x HAL driver implementation features
- * - Clock tree initialization.
- * - Clock source selection.
- * - MAM initialization.
- * .
- * @ingroup LPC214x
- */
-
-/**
- * @defgroup LPC214x_PAL LPC214x PAL Support
- * @details The LPC214x PAL driver uses the FIO peripherals.
- *
- * @section lpc214x_pal_1 Supported HW resources
- * - FIO0.
- * - FIO1.
- * .
- * @section lpc214x_pal_2 LPC214x PAL driver implementation features
- * - 32 bits wide ports.
- * - Atomic set/reset functions.
- * - Output latched regardless of the pad setting.
- * - Direct read of input pads regardless of the pad setting.
- * .
- * @section lpc214x_pal_3 Supported PAL setup modes
- * - @p PAL_MODE_RESET.
- * - @p PAL_MODE_UNCONNECTED.
- * - @p PAL_MODE_INPUT.
- * - @p PAL_MODE_INPUT_ANALOG (same as @p PAL_MODE_INPUT).
- * - @p PAL_MODE_OUTPUT_PUSHPULL.
- * .
- * Any attempt to setup an invalid mode is ignored.
- *
- * @section lpc214x_pal_4 Suboptimal behavior
- * Some FIO features are less than optimal:
- * - Pad/port toggling operations are not atomic.
- * - Pad/group mode setup is not atomic.
- * .
- * @ingroup LPC214x
- */
-
-/**
- * @defgroup LPC214x_SERIAL LPC214x Serial Support
- * @details The LPC214x Serial driver uses the UART peripherals in a
- *          buffered, interrupt driven, implementation. The serial driver
- *          also takes advantage of the LPC214x UARTs deep hardware buffers.
- *
- * @section lpc214x_serial_1 Supported HW resources
- * The serial driver can support any of the following hardware resources:
- * - UART0.
- * - UART1.
- * .
- * @section lpc214x_serial_2 LPC214x Serial driver implementation features
- * - Clock stop for reduced power usage when the driver is in stop state.
- * - Fully interrupt driven.
- * - Programmable interrupt priority levels for each UART.
- * - Takes advantage of the input and output FIFOs.
- * .
- * @ingroup LPC214x
- */
-
-/**
- * @defgroup LPC214x_SPI LPC214x SPI Support
- * @details The SPI driver supports the LPC214x SSP peripheral in an interrupt
- *          driven implementation.
- * @note    Being the SPI a fast peripheral, much care must be taken to
- *          not saturate the CPU bandwidth with an excessive IRQ rate. The
- *          maximum transfer bit rate is likely limited by the IRQ
- *          handling.
- *
- * @section lpc214x_spi_1 Supported HW resources
- * - SSP (SPI0).
- * .
- * @section lpc214x_spi_2 LPC214x SPI driver implementation features
- * - Clock stop for reduced power usage when the driver is in stop state.
- * - Programmable interrupt priority level.
- * .
- * @ingroup LPC214x
- */
-
-/**
- * @defgroup LPC214x_VIC LPC214x VIC Support
- * @details This VIC helper driver is used by the other drivers in order to
- *          access the shared VIC resources in a consistent way.
- *
- * @ingroup LPC214x
- */