// SPDX-License-Identifier: GPL-2.0 /dts-v1/; #include #include "mt7629.dtsi" / { model = "ipTIME A6004MX"; compatible = "iptime,a6004mx", "mediatek,mt7629"; aliases { led-boot = &led_cpu; led-failsafe = &led_cpu; led-running = &led_cpu; led-upgrade = &led_cpu; serial0 = &uart0; }; chosen { stdout-path = "serial0:115200n8"; bootargs-override = "console=ttyS0,115200n8"; }; leds { compatible = "gpio-leds"; led_cpu: cpu { label = "orange:cpu"; gpios = <&pio 57 GPIO_ACTIVE_LOW>; }; wlan5g { label = "orange:wlan5g"; gpios = <&pio 22 GPIO_ACTIVE_LOW>; // linux,default-trigger = "phy0radio"; }; wlan2g { label = "orange:wlan2g"; gpios = <&pio 21 GPIO_ACTIVE_LOW>; // linux,default-trigger = "phy1radio"; }; wan { label = "orange:wan"; gpios = <&pio 12 GPIO_ACTIVE_HIGH>; }; }; keys { compatible = "gpio-keys"; reset { label = "factory"; linux,code = ; gpios = <&pio 60 GPIO_ACTIVE_LOW>; }; wps { label = "wps"; linux,code = ; gpios = <&pio 58 GPIO_ACTIVE_LOW>; }; }; memory@40000000 { device_type = "memory"; reg = <0x40000000 0x10000000>; }; reg_3p3v: regulator-3p3v { compatible = "regulator-fixed"; regulator-name = "fixed-3.3V"; regulator-min-microvolt = <3300000>; regulator-max-microvolt = <3300000>; regulator-boot-on; regulator-always-on; }; reg_5v: regulator-5v { compatible = "regulator-fixed"; regulator-name = "fixed-5V"; regulator-min-microvolt = <5000000>; regulator-max-microvolt = <5000000>; regulator-boot-on; regulator-always-on; }; }; ð { pinctrl-names = "default"; pinctrl-0 = <ð_pins>; pinctrl-1 = <&ephy_leds_pins>; status = "okay"; gmac0: mac@0 { compatible = "mediatek,eth-mac"; reg = <0>; phy-mode = "2500base-x"; nvmem-cells = <&macaddr_factory_4>; nvmem-cell-names = "mac-address"; mac-address-increment = <3>; fixed-link { speed = <2500>; full-duplex; pause; }; }; gmac1: mac@1 { compatible = "mediatek,eth-mac"; reg = <1>; phy-mode = "gmii"; phy-handle = <&phy0>; nvmem-cells = <&macaddr_factory_4>; nvmem-cell-names = "mac-address"; mac-address-increment = <1>; }; mdio: mdio-bus { #address-cells = <1>; #size-cells = <0>; phy0: ethernet-phy@0 { reg = <0>; }; switch@2 { compatible = "mediatek,mt7531"; reg = <2>; reset-gpios = <&pio 28 0>; interrupt-controller; #interrupt-cells = <1>; interrupt-parent = <&pio>; interrupts = <6 IRQ_TYPE_LEVEL_HIGH>; ports { #address-cells = <1>; #size-cells = <0>; port@0 { reg = <0>; label = "lan1"; }; port@1 { reg = <1>; label = "lan2"; }; port@2 { reg = <2>; label = "lan3"; }; port@3 { reg = <3>; label = "lan4"; }; port@6 { reg = <6>; ethernet = <&gmac0>; phy-mode = "2500base-x"; fixed-link { speed = <2500>; full-duplex; pause; }; }; }; }; }; }; &bch { status = "okay"; }; &snfi { pinctrl-names = "default"; pinctrl-0 = <&serial_nand_pins>; status = "okay"; flash@0 { compatible = "spi-nand"; reg = <0>; spi-tx-bus-width = <4>; spi-rx-bus-width = <4>; nand-ecc-engine = <&snfi>; mediatek,bmt-v2; partitions { compatible = "fixed-partitions"; #address-cells = <1>; #size-cells = <1>; partition@0 { label = "Bootloader"; reg = <0x0 0x100000>; read-only; }; partition@100000 { label = "Config"; reg = <0x100000 0x40000>; }; partition@140000 { label = "factory"; reg = <0x140000 0x80000>; read-only; compatible = "nvmem-cells"; #address-cells = <1>; #size-cells = <1>; macaddr_factory_4: macaddr@4 { reg = <0x4 0x6>; }; }; partition@1c0000 { label = "firmware"; reg = <0x1c0000 0x7400000>; compatible = "denx,fit"; openwrt,fit-offset = <0x800>; }; }; }; }; &pio { eth_pins: eth-pins { mux { function = "eth"; groups = "mdc_mdio"; }; }; ephy_leds_pins: ephy-leds-pins { mux { function = "led"; groups = "ephy_leds"; }; }; /* Serial NAND is shared pin with SPI-NOR */ serial_nand_pins: serial-nand-pins { mux { function = "flash"; groups = "snfi"; }; }; uart0_pins: uart0-pins { mux { function = "uart"; groups = "uart0_txd_rxd" ; }; }; watchdog_pins: watchdog-pins { mux { function = "watchdog"; groups = "watchdog"; }; }; }; &ssusb { vusb33-supply = <®_3p3v>; vbus-supply = <®_5v>; status = "okay"; }; &uart0 { pinctrl-names = "default"; pinctrl-0 = <&uart0_pins>; status = "okay"; }; &watchdog { pinctrl-names = "default"; pinctrl-0 = <&watchdog_pins>; status = "okay"; interrupt-controller; #interrupt-cells = <1>; interrupt-parent = <&pio>; interrupts = ; };