From a657978fe7ff4cacc97c753961b75de547e5d5d9 Mon Sep 17 00:00:00 2001 From: Chuanhong Guo Date: Fri, 29 Dec 2017 12:35:32 +0800 Subject: ramips: fix lenovo newifi-y1 switch and LED config There are 3 ethernet ports on Y1. LAN1 on port1, LAN2 on port0 and WAN on port4. Use a standalone switch configuration to match this and use the switch trigger so that LAN LED could indicate the connetction status for both lan ports correctly. This patch also drop the internet led configuration, because there is a WAN led for port4 and eth0.2 isn't always used as WAN. Signed-off-by: Chuanhong Guo --- target/linux/ramips/base-files/etc/board.d/01_leds | 3 +-- target/linux/ramips/base-files/etc/board.d/02_network | 5 ++++- 2 files changed, 5 insertions(+), 3 deletions(-) (limited to 'target') diff --git a/target/linux/ramips/base-files/etc/board.d/01_leds b/target/linux/ramips/base-files/etc/board.d/01_leds index 03d084f17b..55976edec8 100755 --- a/target/linux/ramips/base-files/etc/board.d/01_leds +++ b/target/linux/ramips/base-files/etc/board.d/01_leds @@ -453,8 +453,7 @@ y1) set_usb_led "$boardname:blue:usb" ucidef_set_led_netdev "wifi" "WIFI" "$boardname:blue:wifi" "wlan1" ucidef_set_led_netdev "wifi5g" "WIFI5G" "$boardname:blue:wifi5g" "wlan0" - ucidef_set_led_netdev "lan" "LAN" "$boardname:blue:lan" "eth0.1" "tx rx" - ucidef_set_led_netdev "wan" "WAN" "$boardname:blue:internet" "eth0.2" "tx rx" + ucidef_set_led_switch "lan" "LAN" "$boardname:blue:lan" "switch0" "0x03" ;; y1s) set_usb_led "$boardname:blue:usb" diff --git a/target/linux/ramips/base-files/etc/board.d/02_network b/target/linux/ramips/base-files/etc/board.d/02_network index b8116c773b..48fdfdf3f1 100755 --- a/target/linux/ramips/base-files/etc/board.d/02_network +++ b/target/linux/ramips/base-files/etc/board.d/02_network @@ -111,7 +111,6 @@ ramips_setup_interfaces() wndr3700v5|\ wt1520-4M|\ wt1520-8M|\ - y1|\ youku-yk1|\ zbt-ape522ii|\ zbt-we1326|\ @@ -348,6 +347,10 @@ ramips_setup_interfaces() ucidef_add_switch "switch0" \ "1:lan" "2:lan" "0:wan" "6@eth0" ;; + y1) + ucidef_add_switch "switch0" \ + "0:lan:2" "1:lan:1" "4:wan" "6@eth0" + ;; *) RT3X5X=`cat /proc/cpuinfo | egrep "(RT3.5|RT5350)"` if [ -n "${RT3X5X}" ]; then -- cgit v1.2.3