From 37af596593b0e84d0a076ab8f173066e3d7bc810 Mon Sep 17 00:00:00 2001 From: Cezary Jackiewicz Date: Thu, 19 Apr 2018 19:34:22 +0200 Subject: ramips: add support for D-Link DWR-118-A2 The DWR-118-A2 Wireless Router is based on the MT7620A SoC. Specification: - MediaTek MT7620A (580 Mhz) - 128 MB of RAM - 16 MB of FLASH - 1x 802.11bgn radio - 1x 802.11ac radio (MT7612EN) - 4x 10/100 Mbps Ethernet (1 WAN and 3 LAN) - 1x 10/100/1000 Mbps Marvell Ethernet PHY (1 LAN) - 2x external, non-detachable antennas - 1x USB 2.0 - UART (J1) header on PCB (57600 8n1) - 7x LED (5x GPIO-controlled), 2x button - JBOOT bootloader Known issues: - GELAN not working - flash is very slow The status led has been assigned to the dwr-118-a2:green:internet led. At the end of the boot it is switched off and is available for other operation. Work correctly also during sysupgrade operation. Installation: Apply factory image via http web-gui or JBOOT recovery page How to revert to OEM firmware: - push the reset button and turn on the power. Wait until LED start blinking (~10sec.) - upload original factory image via JBOOT http (IP: 192.168.123.254) Signed-off-by: Cezary Jackiewicz Signed-off-by: Pawel Dembicki --- target/linux/ramips/mt7620/config-4.14 | 1 + 1 file changed, 1 insertion(+) (limited to 'target/linux/ramips/mt7620') diff --git a/target/linux/ramips/mt7620/config-4.14 b/target/linux/ramips/mt7620/config-4.14 index 89de071446..1162ed47b2 100644 --- a/target/linux/ramips/mt7620/config-4.14 +++ b/target/linux/ramips/mt7620/config-4.14 @@ -128,6 +128,7 @@ CONFIG_IRQ_INTC=y CONFIG_IRQ_MIPS_CPU=y CONFIG_IRQ_WORK=y CONFIG_LIBFDT=y +CONFIG_MARVELL_PHY=y CONFIG_MDIO_BUS=y CONFIG_MDIO_DEVICE=y CONFIG_MFD_SYSCON=y -- cgit v1.2.3