From f2c83532f92c5fa43165e1c5a3cd7f5cf4e9e3b3 Mon Sep 17 00:00:00 2001 From: Kip Porterfield Date: Sun, 3 Feb 2019 13:54:18 -0500 Subject: ramips: add support for Belkin F9K1109v1 Device specification: - SoC: Ralink RT3883 (MIPS 74Kc) 500Mhz - RAM: 64Mb - Flash: 8MB (SPI-NOR) - Ethernet: 10/100/1000 Mbps - WLAN Wireless 1: SoC-integrated : 2.4/5 GHz Wireless 2: 2.4 GHz RT3092L - LED: 2x USB, WAN, LAN - Key: WPS, reset - Serial: 4-pin header, (57600,8,N,1), 3.3V TTL, GND, RX, TX, V - J12 marking on board - USB ports: 2 x USB 2.0 Flashing instructions: Option 1 (from bootloader web) - Hold reset button on the back of router when plugging in power (for at-least 10 seconds after plugged in) - Connect to a Lan port - Set computer IP to 10.10.10.3 - Go to http://10.10.10.123 in a web browser - Click the Browse... Button and select the *squashfs.sysupgrade.bin file then click APPLY Option 2 (from the stock admin web) - Go to firmware upgrade - Upload the **factory** image *initramfs.bin first - Boot into openwrt - From Luci web in openwrt upload the *squashfs.sysupgrade.bin Signed-off-by: Kip Porterfield Signed-off-by: Christian Lamparter [added v1 to the compatible identifier, added pciid for the RT3092L, fixed pci unit-address, split out the F9K110X.dtsi to prepare for a possible F9K1103 patch] --- target/linux/ramips/base-files/etc/board.d/01_leds | 4 ++++ target/linux/ramips/base-files/etc/board.d/02_network | 5 +++++ 2 files changed, 9 insertions(+) (limited to 'target/linux/ramips/base-files') diff --git a/target/linux/ramips/base-files/etc/board.d/01_leds b/target/linux/ramips/base-files/etc/board.d/01_leds index cbc003a1de..df5dd84d5a 100755 --- a/target/linux/ramips/base-files/etc/board.d/01_leds +++ b/target/linux/ramips/base-files/etc/board.d/01_leds @@ -60,6 +60,10 @@ bdcom,wap2100-sk|\ hiwifi,hc5861b) set_wifi_led "$boardname:green:wlan2g" ;; +belkin,f9k1109v1) + set_usb_led "$boardname:green:usb1" + ucidef_set_led_netdev "lan" "lan" "$boardname:blue:wps" "eth0" + ;; broadway) set_wifi_led "$boardname:red:wps_active" ;; diff --git a/target/linux/ramips/base-files/etc/board.d/02_network b/target/linux/ramips/base-files/etc/board.d/02_network index f968aafc8e..8417ac68ab 100755 --- a/target/linux/ramips/base-files/etc/board.d/02_network +++ b/target/linux/ramips/base-files/etc/board.d/02_network @@ -199,6 +199,7 @@ ramips_setup_interfaces() ucidef_add_switch "switch0" \ "0:wan" "1:lan" "2:lan" "3:lan" "4:lan" "6t@eth0" ;; + belkin,f9k1109v1|\ rt-n15|\ wl-351) ucidef_add_switch "switch0" \ @@ -483,6 +484,10 @@ ramips_setup_macs() lan_mac=$(macaddr_setbit_la "$lan_mac") wan_mac=$(macaddr_add "$lan_mac" 1) ;; + belkin,f9k1109v1) + wan_mac=$(mtd_get_mac_ascii uboot-env HW_WAN_MAC) + lan_mac=$(mtd_get_mac_ascii uboot-env HW_LAN_MAC) + ;; br-6475nd) lan_mac=$(cat /sys/class/net/eth0/address) wan_mac=$(mtd_get_mac_binary devdata 7) -- cgit v1.2.3