aboutsummaryrefslogtreecommitdiffstats
path: root/target
Commit message (Collapse)AuthorAgeFilesLines
* d-link: Add DIR-601 Profile Definition; It needs different factory images ↵Daniel Dickinson2012-02-162-0/+19
| | | | | | than DIR-600 SVN-Revision: 30570
* Fix partitions for Cameo-based boards; kernel 3.2 is biggerDaniel Dickinson2012-02-161-4/+4
| | | | SVN-Revision: 30569
* image: For Cameo-based board fix adding mtd layout to kernel commandline)Daniel Dickinson2012-02-161-1/+1
| | | | SVN-Revision: 30568
* linux 3.2: missing generic symbolsJo-Philipp Wich2012-02-151-0/+2
| | | | | | | | These symbols are dependent on CONFIG_PCI being enabled. Signed-off-by: Philip Prindeville <philipp@redfish-solutions.com> SVN-Revision: 30565
* ramips: rt288x: fix PCI resource conflictGabor Juhos2012-02-151-0/+8
| | | | SVN-Revision: 30563
* correct PCI IO/Mem resource swappingFlorian Fainelli2012-02-151-4/+4
| | | | SVN-Revision: 30562
* add Ralink V11ST-FE board supportFlorian Fainelli2012-02-1511-0/+134
| | | | | | | | | | This board is equipped with: - 4MB of NOR Flash - 32MB of SDRAM - IC+ IP175C switch - one Mini-PCI slot SVN-Revision: 30561
* ramips: raeth: add a helper function for skb allocationGabor Juhos2012-02-151-6/+16
| | | | SVN-Revision: 30555
* ramips: raeth: use netdev_alloc_skbGabor Juhos2012-02-151-2/+3
| | | | SVN-Revision: 30554
* ramips: raeth: add '__packed __aligned(4)' annotation to dma descritor ↵Gabor Juhos2012-02-151-2/+2
| | | | | | | | structures This helps GCC to generare more efficient code. SVN-Revision: 30553
* ramips: raeth: use 're' instead of 'priv' everywhereGabor Juhos2012-02-151-73/+73
| | | | SVN-Revision: 30552
* ramips: raeth: force link down in ramips_phy_stopGabor Juhos2012-02-151-7/+6
| | | | SVN-Revision: 30550
* ramips: raeth: serialize ramips_link_adjust callsGabor Juhos2012-02-151-0/+8
| | | | SVN-Revision: 30549
* ramips: raeth: add PHYLIB supportGabor Juhos2012-02-155-10/+229
| | | | SVN-Revision: 30547
* linux-atm: update solos-pci driver to upstreamJohn Crispin2012-02-143-0/+1044
| | | | | | | | | | | | | Fixes for the solos-pci driver. - Corrects calculation of headroom for padding. - Removes pointless debug messages. - Expose Bis A and Bis M annex capabilities. - Expose hardware revision. Signed-off-by: Philip Prindeville <philipp_subx@redfish-solutions.com> SVN-Revision: 30541
* linux-atm: headroom/padding fixesJohn Crispin2012-02-143-0/+249
| | | | | | | | Submitted upstream to netdev by Chas Williams on linux-atm. Signed-off-by: Philip Prindeville <philipp_subx@redfish-solutions.com> SVN-Revision: 30540
* generate uboot environment data in targetJohn Crispin2012-02-141-0/+32
| | | | | | | | | | | With this patch it is possible to generate uboot environment config file inside lantiq target. Currently it is only supporting GIGASX76X board. uboot environment config is used by fw_printenv fw_setenv tools. Signed-off-by: Luka Perkov <openwrt@lukaperkov.net> SVN-Revision: 30537
* fix compile error in previous commitJohn Crispin2012-02-141-10/+10
| | | | SVN-Revision: 30534
* Support booting the Speedport W502V using BRN-BOOT.John Crispin2012-02-143-7/+158
| | | | | | | | | | | | | | | | | | | | | | | | | | | | | While the disadvantage is less available flash space, it's easy and safe to flash without opening the device. Going back to the original firmware is also possible. This patch add two firmware utilities, mkbrncmdline and mkbrnboot. mkbrncmdline patches the uncompressed kernel so the registeres a0 to a3 are initialized and the memory size is passed in. mkbrnboot takes the lzma compressed kernel and squashfs images and creates a firmware image that can be flashed using the BRN-BOOT recovery kernel, which is booted by holding both buttons when powering up the device and will listen on http://192.168.2.1. The firmware file from bin/lantiq/ to use is openwrt-lantiq-danube-ARV4525PW-BRNDTW502-brnImage The BRN-BOOT recovery kernel does size-check the image, so if it's too big to fit into flash it will complain accordingly. A second patch is needed to make the wired network interface work since there is no u-boot to pre-initialise it. Signed-off-by: Tobias Diedrich <ranma+openwrt@tdiedrich.de> SVN-Revision: 30532
* ramips: extract eeprom for the PCIe wlan module on the RT-N56UGabor Juhos2012-02-141-4/+12
| | | | SVN-Revision: 30529
* ramips: rt3883: enable PCI on the RT-N56U boardGabor Juhos2012-02-141-0/+16
| | | | SVN-Revision: 30528
* ramips: rt3883: add PCI supportGabor Juhos2012-02-148-1/+548
| | | | SVN-Revision: 30527
* ramips: rt3883: sync 2.6.39 configGabor Juhos2012-02-141-7/+3
| | | | SVN-Revision: 30526
* ramips: use SoC specific irq.hGabor Juhos2012-02-143-3/+36
| | | | SVN-Revision: 30525
* fixes irq locking in ethernet driverJohn Crispin2012-02-141-0/+71
| | | | SVN-Revision: 30522
* fixes gpio_export patchJohn Crispin2012-02-141-8/+8
| | | | SVN-Revision: 30521
* add annex selection support to ltq_dsl packageJohn Crispin2012-02-142-5/+27
| | | | SVN-Revision: 30518
* ar71xx: add profile and build image for the TP-Link TL-WR842N/ND v1 boardsGabor Juhos2012-02-132-0/+17
| | | | SVN-Revision: 30508
* ar71xx: add model detection for TL-WR842N/NDGabor Juhos2012-02-131-0/+3
| | | | SVN-Revision: 30507
* update to 3.2Florian Fainelli2012-02-131-1/+1
| | | | SVN-Revision: 30503
* fix titan gpio register sizeFlorian Fainelli2012-02-131-0/+33
| | | | SVN-Revision: 30502
* ramips: rt3883: update package list in the default profileGabor Juhos2012-02-131-1/+1
| | | | SVN-Revision: 30499
* ramips: add preliminary support for the Asus RT-N56U boardGabor Juhos2012-02-1311-0/+174
| | | | SVN-Revision: 30498
* ramips: raeth: enable MDIO code for RT3883Gabor Juhos2012-02-131-2/+2
| | | | SVN-Revision: 30497
* ramips: add preliminary support for the RT3662/RT3883 SoCsGabor Juhos2012-02-1340-9/+2286
| | | | SVN-Revision: 30495
* add support for 3.2Florian Fainelli2012-02-131-0/+14
| | | | SVN-Revision: 30492
* brcm47xx: deactivate CONFIG_NO_HZ as it seams not to be needed.Hauke Mehrtens2012-02-122-2/+0
| | | | SVN-Revision: 30488
* brcm47xx: activate config bug to show warningsHauke Mehrtens2012-02-122-2/+0
| | | | SVN-Revision: 30487
* ramips: use GENERIC_{4,8}M image template for WR5123GNGabor Juhos2012-02-121-5/+2
| | | | SVN-Revision: 30483
* ramips: rt305x: pass MTD partition map to the ALL0256N via cmdlineGabor Juhos2012-02-121-1/+2
| | | | SVN-Revision: 30482
* brcm47xx: refresh patchesHauke Mehrtens2012-02-128-31/+20
| | | | SVN-Revision: 30481
* brcm47xx: update usb driver for brcm47xx.Hauke Mehrtens2012-02-128-390/+280
| | | | SVN-Revision: 30480
* ramips: add initial support for 3.2Gabor Juhos2012-02-1213-1/+607
| | | | SVN-Revision: 30476
* ramips: include 'linux/module.h' in the ramips_spi driverGabor Juhos2012-02-121-0/+1
| | | | SVN-Revision: 30475
* ramips: rt288x: remove per-board physmap_flash_data instancesGabor Juhos2012-02-126-28/+30
| | | | SVN-Revision: 30474
* ramips: rt305x: remove per-board physmap_flash_data instancesGabor Juhos2012-02-1221-120/+93
| | | | SVN-Revision: 30473
* enable another l2 cache errate on newer kernelsImre Kaloz2012-02-121-0/+1
| | | | SVN-Revision: 30472
* ramips: load gpio-polled keys moduleGabor Juhos2012-02-111-1/+1
| | | | SVN-Revision: 30463
* ramips: remove yet another CONFIG_MTD_PARTITION ifdefGabor Juhos2012-02-111-2/+0
| | | | SVN-Revision: 30462
* ramips: use gpio-keys-polled instead of gpio-buttonsGabor Juhos2012-02-1127-138/+159
| | | | SVN-Revision: 30461
generated by cgit v1.2.3 (git 2.25.1) at 2024-11-14 23:35:46 +0000