diff options
Diffstat (limited to 'target/linux')
5 files changed, 325 insertions, 1 deletions
diff --git a/target/linux/ipq806x/base-files/etc/board.d/02_network b/target/linux/ipq806x/base-files/etc/board.d/02_network index fbf56c5e0c..ddef4b7ac6 100755 --- a/target/linux/ipq806x/base-files/etc/board.d/02_network +++ b/target/linux/ipq806x/base-files/etc/board.d/02_network @@ -66,6 +66,9 @@ qcom,ipq8064-db149) ucidef_add_switch "switch0" \ "1:lan" "2:lan" "3:lan" "4:lan" "6u@eth1" "5:wan" "0u@eth0" ;; +ubnt,unifi-ac-hd) + ucidef_set_interface_lan "eth0 eth1" + ;; zyxel,nbg6817) hw_mac_addr=$(mtd_get_mac_ascii 0:APPSBLENV ethaddr) ucidef_add_switch "switch0" \ diff --git a/target/linux/ipq806x/base-files/etc/hotplug.d/ieee80211/10_fix_wifi_mac b/target/linux/ipq806x/base-files/etc/hotplug.d/ieee80211/10_fix_wifi_mac index f0256fd259..5af3a5b805 100644 --- a/target/linux/ipq806x/base-files/etc/hotplug.d/ieee80211/10_fix_wifi_mac +++ b/target/linux/ipq806x/base-files/etc/hotplug.d/ieee80211/10_fix_wifi_mac @@ -9,6 +9,14 @@ PHYNBR=${DEVPATH##*/phy} . /lib/functions.sh . /lib/functions/system.sh +board=$(board_name) + +case "$board" in + ubnt,unifi-ac-hd) + macaddr_add $(mtd_get_mac_binary EEPROM 0x6) $(($PHYNBR + 1)) > /sys${DEVPATH}/macaddress + ;; +esac + OPATH=${DEVPATH##/devices/platform/} OPATH=${OPATH%%/ieee*} diff --git a/target/linux/ipq806x/files/arch/arm/boot/dts/qcom-ipq8064-unifi-ac-hd.dts b/target/linux/ipq806x/files/arch/arm/boot/dts/qcom-ipq8064-unifi-ac-hd.dts new file mode 100644 index 0000000000..c637da24a9 --- /dev/null +++ b/target/linux/ipq806x/files/arch/arm/boot/dts/qcom-ipq8064-unifi-ac-hd.dts @@ -0,0 +1,300 @@ +// SPDX-License-Identifier: GPL-2.0-or-later OR MIT + +#include "qcom-ipq8064-v2.0.dtsi" + +#include <dt-bindings/gpio/gpio.h> +#include <dt-bindings/input/input.h> + +/ { + model = "Ubiquiti UniFi AC HD"; + compatible = "ubnt,unifi-ac-hd", "qcom,ipq8064"; + + aliases { + label-mac-device = &gmac2; + led-boot = &led_dome_white; + led-failsafe = &led_dome_white; + led-running = &led_dome_blue; + led-upgrade = &led_dome_blue; + mdio-gpio0 = &mdio0; + }; + + leds { + compatible = "gpio-leds"; + pinctrl-0 = <&led_pins>; + pinctrl-names = "default"; + + led_dome_blue: dome_blue { + label = "blue:dome"; + gpios = <&qcom_pinmux 9 GPIO_ACTIVE_HIGH>; + }; + + led_dome_white: dome_white { + label = "white:dome"; + gpios = <&qcom_pinmux 53 GPIO_ACTIVE_HIGH>; + }; + }; + + keys { + compatible = "gpio-keys"; + pinctrl-0 = <&button_pins>; + pinctrl-names = "default"; + + reset { + label = "reset"; + gpios = <&qcom_pinmux 68 GPIO_ACTIVE_LOW>; + linux,code = <KEY_RESTART>; + debounce-interval = <60>; + }; + }; +}; + +&qcom_pinmux { + button_pins: button_pins { + mux { + pins = "gpio68"; + function = "gpio"; + drive-strength = <2>; + bias-pull-up; + }; + }; + + led_pins: led_pins { + mux { + pins = "gpio9", "gpio53"; + function = "gpio"; + drive-strength = <2>; + bias-pull-down; + output-low; + }; + }; + + spi_pins: spi_pins { + mux { + pins = "gpio18", "gpio19", "gpio21"; + function = "gsbi5"; + drive-strength = <10>; + bias-none; + }; + + cs { + pins = "gpio20"; + drive-strength = <12>; + }; + }; +}; + +&CPU_SPC { + status = "disabled"; +}; + +&gsbi5 { + status = "okay"; + + qcom,mode = <GSBI_PROT_SPI>; + + spi@1a280000 { + status = "okay"; + + pinctrl-0 = <&spi_pins>; + pinctrl-names = "default"; + cs-gpios = <&qcom_pinmux 20 0>; + + flash@0 { + compatible = "mx25u25635f", "jedec,spi-nor"; + #address-cells = <1>; + #size-cells = <1>; + spi-max-frequency = <50000000>; + reg = <0>; + m25p,fast-read; + + partitions { + compatible = "fixed-partitions"; + #address-cells = <1>; + #size-cells = <1>; + + partition@0 { + label = "SBL1"; + reg = <0x0 0x20000>; + read-only; + }; + + partition@20000 { + label = "MIBIB"; + reg = <0x20000 0x10000>; + read-only; + }; + + partition@30000 { + label = "SBL2"; + reg = <0x30000 0x20000>; + read-only; + }; + + partition@50000 { + label = "SBL3"; + reg = <0x50000 0x30000>; + read-only; + }; + + partition@80000 { + label = "DDRCONFIG"; + reg = <0x80000 0x10000>; + read-only; + }; + + partition@90000 { + label = "SSD"; + reg = <0x90000 0x100000>; + read-only; + }; + + partition@a0000 { + label = "TZ"; + reg = <0xa0000 0x30000>; + read-only; + }; + + partition@d0000 { + label = "RPM"; + reg = <0xd0000 0x20000>; + read-only; + }; + + partition@f0000 { + label = "APPSBL"; + reg = <0xf0000 0xc0000>; + read-only; + }; + + partition@1b0000 { + label = "APPSBLENV"; + reg = <0x1b0000 0x10000>; + read-only; + }; + + eeprom: partition@1c0000 { + label = "EEPROM"; + reg = <0x1c0000 0x10000>; + read-only; + }; + + partition@1d0000 { + label = "bootselect"; + reg = <0x1d0000 0x10000>; + }; + + partition@1e0000 { + compatible = "denx,fit"; + label = "firmware"; + reg = <0x1e0000 0xe70000>; + }; + + partition@1050000 { + label = "kernel1"; + reg = <0x1050000 0xe70000>; + read-only; + }; + + partition@1ec0000 { + label = "debug"; + reg = <0x1ec0000 0x100000>; + read-only; + }; + + partition@1fc0000 { + label = "cfg"; + reg = <0x1fc0000 0x40000>; + read-only; + }; + }; + }; + }; +}; + +&adm_dma { + status = "okay"; +}; + +&nand_controller { + status = "okay"; + + pinctrl-0 = <&nand_pins>; + pinctrl-names = "default"; + nand-ecc-strength = <4>; + nand-bus-width = <8>; +}; + +&mdio0 { + status = "okay"; + + pinctrl-0 = <&mdio0_pins>; + pinctrl-names = "default"; +}; + +&gmac2 { + status = "okay"; + + phy-mode = "sgmii"; + qcom,id = <2>; + qcom,emulation = <0>; + mdiobus = <&mdio0>; + + mtd-mac-address = <&eeprom 0x0>; + + fixed-link { + speed = <1000>; + full-duplex; + }; +}; + +&gmac1 { + status = "okay"; + + phy-mode = "sgmii"; + qcom,id = <1>; + qcom,emulation = <0>; + mdiobus = <&mdio0>; + + mtd-mac-address = <&eeprom 0x6>; + + fixed-link { + speed = <1000>; + full-duplex; + }; +}; + +&pcie0 { + status = "okay"; +}; + +&pcie1 { + status = "okay"; +}; + +&tcsr { + status = "okay"; +}; + +&hs_phy_0 { + status = "okay"; +}; + +&ss_phy_0 { + status = "okay"; +}; + +&usb3_0 { + status = "okay"; +}; + +&hs_phy_1 { + status = "okay"; +}; + +&ss_phy_1 { + status = "okay"; +}; + +&usb3_1 { + status = "okay"; +}; diff --git a/target/linux/ipq806x/image/Makefile b/target/linux/ipq806x/image/Makefile index b77c0a99c0..bc917d4fa4 100644 --- a/target/linux/ipq806x/image/Makefile +++ b/target/linux/ipq806x/image/Makefile @@ -382,6 +382,18 @@ define Device/tplink_vr2600v endef TARGET_DEVICES += tplink_vr2600v +define Device/ubnt_unifi-ac-hd + $(call Device/FitImageLzma) + DEVICE_VENDOR := Ubiquiti + DEVICE_MODEL := UniFi AC HD + SOC := qcom-ipq8064 + BLOCKSIZE := 64k + IMAGE_SIZE := 14784k + DEVICE_PACKAGES := ath10k-firmware-qca9984-ct + IMAGE/sysupgrade.bin := append-kernel | pad-to $$$$(BLOCKSIZE) | append-rootfs | pad-rootfs | append-metadata | check-size +endef +TARGET_DEVICES += ubnt_unifi-ac-hd + define Device/zyxel_nbg6817 DEVICE_VENDOR := ZyXEL DEVICE_MODEL := NBG6817 diff --git a/target/linux/ipq806x/patches-5.4/0069-arm-boot-add-dts-files.patch b/target/linux/ipq806x/patches-5.4/0069-arm-boot-add-dts-files.patch index a5fce41112..055a4cbc30 100644 --- a/target/linux/ipq806x/patches-5.4/0069-arm-boot-add-dts-files.patch +++ b/target/linux/ipq806x/patches-5.4/0069-arm-boot-add-dts-files.patch @@ -10,7 +10,7 @@ Signed-off-by: John Crispin <john@phrozen.org> --- a/arch/arm/boot/dts/Makefile +++ b/arch/arm/boot/dts/Makefile -@@ -842,7 +842,23 @@ dtb-$(CONFIG_ARCH_QCOM) += \ +@@ -842,7 +842,24 @@ dtb-$(CONFIG_ARCH_QCOM) += \ qcom-ipq4019-ap.dk04.1-c3.dtb \ qcom-ipq4019-ap.dk07.1-c1.dtb \ qcom-ipq4019-ap.dk07.1-c2.dtb \ @@ -25,6 +25,7 @@ Signed-off-by: John Crispin <john@phrozen.org> + qcom-ipq8064-g10.dtb \ + qcom-ipq8064-r7500.dtb \ + qcom-ipq8064-r7500v2.dtb \ ++ qcom-ipq8064-unifi-ac-hd.dtb \ + qcom-ipq8064-wg2600hp.dtb \ + qcom-ipq8064-wpq864.dtb \ + qcom-ipq8064-wxr-2533dhp.dtb \ |