ar71xx: add support for TP-Link TL-WR902AC v1

TP-Link TL-WR902AC v1 is a pocket-size, dual-band (AC750), successor of
TL-MR3020 (both devices use very similar enclosure, in same size). New
device is based on Qualcomm QCA9531 v2 + QCA9887. FCC ID: TE7WR902AC.

Specification:

- 650/391/216 MHz (CPU/DDR/AHB)
- 1x 10/100 Mbps Ethernet
- 1x USB 2.0 (GPIO-controlled power)
- 64 MB of RAM (DDR2)
- 8 MB of FLASH
- 2T2R 2.4 GHz (QCA9531)
- 1T1R 5 GHz (QCA9887)
- 5x LED (GPIO-controlled), 2x button, 1x 3-pos switch
- UART pads on PCB (TP1 -> TX, TP2 -> RX, TP3 -> GND, TP4 -> 3V3, jumper
  resitors are missing on TX/RX lines)
- 1x micro USB (for power only)

Flash instructions:

Use "factory" image under vendor GUI.

Recovery instructions:

This device contains tftp recovery mode inside U-Boot. You can use it to
flash LEDE (use "factory" image) or vendor firmware.

1. Configure PC with static IP 192.168.0.66/24 and tftp server.
2. Rename "lede-ar71xx-generic-tl-wr902ac-v1-squashfs-factory.bin"
   to "wr902acv1_un_tp_recovery.bin" and place it in tftp server dir.
3. Connect PC with LAN port, press the reset button, power up the router
   and keep button pressed until WPS LED lights up.
4. Router will download file from server, write it to flash and reboot.

Root access over serial line in vendor firmware: root/sohoadmin.

Signed-off-by: Piotr Dymacz <pepe2k@gmail.com>

4 files changed, 10 insertions, 2 deletions

diff --git a/target/linux/ar71xx/base-files/etc/board.d/01_leds b/target/linux/ar71xx/base-files/etc/board.d/01_leds
index de9072e55c..103002d54a 100755
--- a/target/linux/ar71xx/base-files/etc/board.d/01_leds
+++ b/target/linux/ar71xx/base-files/etc/board.d/01_leds
@@ -750,6 +750,11 @@ tl-wr802n-v1)
 tl-wr802n-v2)
 	ucidef_set_led_wlan "wlan" "WLAN" "$board:green:system" "phy0tpt"
 	;;
+tl-wr902ac-v1)
+	ucidef_set_led_netdev "wan" "WAN" "$board:green:lan" "eth0"
+	ucidef_set_led_usbdev "usb" "USB" "$board:green:usb" "1-1"
+	ucidef_set_led_wlan "wlan2g" "WLAN2G" "$board:green:wlan2g" "phy1tpt"
+	;;
 tl-wr940n-v4|\
 tl-wr941nd-v6)
 	ucidef_set_led_netdev "wan" "WAN" "tp-link:blue:wan" "eth0"
diff --git a/target/linux/ar71xx/base-files/etc/board.d/02_network b/target/linux/ar71xx/base-files/etc/board.d/02_network
index 23c50b41d6..b9b7b3cb27 100755
--- a/target/linux/ar71xx/base-files/etc/board.d/02_network
+++ b/target/linux/ar71xx/base-files/etc/board.d/02_network
@@ -124,6 +124,7 @@ ar71xx_setup_interfaces()
 	tl-wr703n|\
 	tl-wr802n-v1|\
 	tl-wr802n-v2|\
+	tl-wr902ac-v1|\
 	tube2h|\
 	unifiac-lite|\
 	wndap360|\
diff --git a/target/linux/ar71xx/base-files/etc/diag.sh b/target/linux/ar71xx/base-files/etc/diag.sh
index 2d2a6788a7..50b893f5b1 100644
--- a/target/linux/ar71xx/base-files/etc/diag.sh
+++ b/target/linux/ar71xx/base-files/etc/diag.sh
@@ -61,7 +61,8 @@ get_status_led() {
 	nbg6616|\
 	sc1750|\
 	sc450|\
-	tl-wpa8630)
+	tl-wpa8630|\
+	tl-wr902ac-v1)
 		status_led="$board:green:power"
 		;;
 	ap90q|\
diff --git a/target/linux/ar71xx/base-files/etc/hotplug.d/firmware/11-ath10k-caldata b/target/linux/ar71xx/base-files/etc/hotplug.d/firmware/11-ath10k-caldata
index ecbc9b8163..a2e98f4be7 100644
--- a/target/linux/ar71xx/base-files/etc/hotplug.d/firmware/11-ath10k-caldata
+++ b/target/linux/ar71xx/base-files/etc/hotplug.d/firmware/11-ath10k-caldata
@@ -98,7 +98,8 @@ case "$FIRMWARE" in
 	rb-952ui-5ac2nd)
 		ath10kcal_from_file "/sys/firmware/routerboot/ext_wlan_data" 20480 2116
 		;;
-	re450)
+	re450|\
+	tl-wr902ac-v1)
 		ath10kcal_extract "art" 20480 2116
 		ath10kcal_patch_mac $(macaddr_add $(cat /sys/class/net/eth0/address) -2)
 		;;