From 4c24ad4bdfcd6a2453b550f1964da9617a33d97e Mon Sep 17 00:00:00 2001 From: Carl-Daniel Hailfinger Date: Sat, 9 May 2009 07:24:23 +0000 Subject: Trim default ICH SPI delay from 1000 to 10 microseconds Since many commands take around 10 microseconds to complete, it is totally pointless to wait for 1000 microseconds before checking the status again. This patch is tested and reduced write time on ICH7 with SST25VF080B from over one hour to 62 seconds. Thanks to Ali Nadalizadeh for testing! Corresponding to flashrom svn r487. Signed-off-by: Carl-Daniel Hailfinger Acked-by: Myles Watson --- ichspi.c | 8 ++++---- 1 file changed, 4 insertions(+), 4 deletions(-) (limited to 'ichspi.c') diff --git a/ichspi.c b/ichspi.c index e25237ad..ea807953 100644 --- a/ichspi.c +++ b/ichspi.c @@ -458,9 +458,9 @@ static int ich7_run_opcode(OPCODE op, uint32_t offset, REGWRITE16(ICH7_REG_SPIC, temp16); /* wait for cycle complete */ - timeout = 1000 * 60; // 60s is a looong timeout. + timeout = 100 * 1000 * 60; // 60s is a looong timeout. while (((REGREAD16(ICH7_REG_SPIS) & SPIS_CDS) == 0) && --timeout) { - myusec_delay(1000); + myusec_delay(10); } if (!timeout) { printf_debug("timeout\n"); @@ -575,9 +575,9 @@ static int ich9_run_opcode(OPCODE op, uint32_t offset, REGWRITE32(ICH9_REG_SSFS, temp32); /*wait for cycle complete */ - timeout = 1000 * 60; // 60s is a looong timeout. + timeout = 100 * 1000 * 60; // 60s is a looong timeout. while (((REGREAD32(ICH9_REG_SSFS) & SSFS_CDS) == 0) && --timeout) { - myusec_delay(1000); + myusec_delay(10); } if (!timeout) { printf_debug("timeout\n"); -- cgit v1.2.3