aboutsummaryrefslogtreecommitdiffstats
path: root/Projects
Commit message (Collapse)AuthorAgeFilesLines
* Removed software PDI/TPI emulation from the AVRISP-MKII clone project, as it ↵Dean Camera2010-05-043-293/+8
| | | | was very buggy. PDI and TPI must now be implemented via seperate headers instead of the one unified ISP/TPI/PDI header.
* Fixed device state not being reset back to the default state if the host ↵Dean Camera2010-05-041-2/+3
| | | | | | | | sets the address to 0x00. Fixed Set Configuration requests not being stalled until the host has set the device's address. Fixed possibility of internal signature retrieval being corrupted if an interrupt occurs during a signature byte read (thanks to Andrei Krainev).
* Added new ENDPOINT_*_BusSuspended error code to the Endpoint function, so ↵Dean Camera2010-05-031-2/+2
| | | | that the stream functions early-abort if the bus is suspended before or during a transfer.
* Increase hardware PDI/TPI programming speed to 1MHz in the AVRISP MKII clone ↵Dean Camera2010-05-023-3/+4
| | | | project.
* Switch back to C based timeout ISR in the AVRISP project - assembly version ↵Dean Camera2010-05-024-25/+21
| | | | was failing, and only one or two cycles could be shaved off the compiler generated code.
* Change AVRISP project's timeout to be interrupt based again, but make the ↵Dean Camera2010-05-029-116/+63
| | | | | | interrupt itself interruptable and use a seperate assembly file to hand-optimize the ISR code. Removed the cast to uint16_t on the set baud rate in the USBtoSerial project, so that the higher >1M baud rates can be selected (thanks to Steffan).
* Make sure that long reads are aborted early if the connection times out ↵Dean Camera2010-04-303-5/+8
| | | | while waiting on more bytes in the AVRISP MKII clone project.
* Make sure that the NVM bus/controller busy waits in the AVRISP MKII clone ↵Dean Camera2010-04-303-15/+54
| | | | project abort properly if a timeout occurs while waiting for a response.
* Relocate USBInterrupt.c/.h from the HighLevel USB driver directory to the ↵Dean Camera2010-04-2812-24/+24
| | | | LowLevel directory as it is hardware-dependent.
* USB_Init() no longer calls sei() to enable global interrupts - this must now ↵Dean Camera2010-04-2820-6/+30
| | | | be done in the user application once all init code has run.
* Make AVRISP-MKII clone project's software PDI/TPI mode more robust by ↵Dean Camera2010-04-281-14/+25
| | | | keeping track of timeouts while waiting for a Tx/Rx to finish.
* Added ability to search by Channel PSM to the GetChannelData() function in ↵Dean Camera2010-04-221-1/+1
| | | | | | | | | | the BluetoothHost demo. Added new HCI states to properly initialize the bluetooth dongle and retrieve the local BDADDR. Factored out Bluetooth state information into a new state structure for easy reference in the user application. Added new StackInitialized() Bluetooth stack callback function.
* Add const keyword to the demo function parameters where possible.Dean Camera2010-04-1821-60/+60
|
* Fixed Set/Clear Feature requests directed to a non-configured endpoint not ↵Dean Camera2010-04-141-1/+1
| | | | | | returning a stall to the host. Make TeensyHID bootloader use an 8 byte control endpoint to match the official Teensy, just in case Paul decides to authenticate on that attribute in the future.
* Document the Bluetooth ACL layer. Remove unneeded parameters from the ↵Dean Camera2010-04-131-1/+1
| | | | | | | | signalling command processing routines. Change over the code so that the bluetooth packet data is read in by the stack rather than the user application, to make it more unform for sending/receiving, and so the library can handle incomming fragmentation in the future. Start Service Discovery Protocol decoding and processing.
* Add information request/response signal handler to the Bluetooth Host demo.Dean Camera2010-04-065-5/+5
| | | | Ensure that the AVRISP-MKII project's Windows avrdude compatibility define is named properly in all parts of the code.
* Add user callback function to the Bluetooth host demo to filter out ↵Dean Camera2010-04-053-17/+25
| | | | | | | | connections from remote devices. Add in ability to reject connections based on their bluetooth device address. Clean up RelayBoard project code. Make AVRISP project clear the XMEGA target's reset register twice; this does not appear to take affect properly the first time under some circumstances.
* More improvements to the incomplete BluetoothHost demo - add Disconnection ↵Dean Camera2010-04-011-3/+0
| | | | | | Event processing. Remove unused macro in the host mode demos for the maximum Configuration Descriptor size.
* Added WIN_LIBUSB_COMPAT compile time option to the AVRISP programmer project ↵Dean Camera2010-03-3114-17/+100
| | | | to make the code compatible with Windows builds of avrdude at the expense of AVRStudio compatibility.
* Add RelayBoard project patch from OBinou.Dean Camera2010-03-311-10/+10
|
* Added board hardware driver support for the Benito programmer.Dean Camera2010-03-302-111/+1
|
* Add briefs for the library core structures.Dean Camera2010-03-292-5/+1
|
* All Class Driver Host mode demos now correctly set the board LEDs to READY ↵Dean Camera2010-03-254-1/+4
| | | | | | once the enumeration process has completed. Fixed Still Image Host class driver not resetting the transaction ID when a new session is opened, fixed driver not sending a valid session ID to the device.
* Added new Relay Controller Board project (thanks to OBinou).Dean Camera2010-03-248-0/+2861
| | | | Added hardware board driver support for the PJRC Teensy line of USB AVR boards.
* Fixed compilation error in the AudioInput demos when ↵Dean Camera2010-03-241-1/+1
| | | | | | | | MICROPHONE_BIASED_TO_HALF_RAIL is defined (thanks to C. Scott Ananian). Minor documentation cleanups. Make sure HID class driver uses properly cast pointers when writing to the report buffer.
* Change over MIDIToneGenerator to use only a single channel (MIDI channel 1) ↵Dean Camera2010-03-231-36/+12
| | | | due to cycle constraints.
* Added incomplete MIDIToneGenerator project.Dean Camera2010-03-235-0/+1430
|
* Standardized the naming scheme given to configuration descriptor ↵Dean Camera2010-03-2221-91/+92
| | | | | | sub-elements in the Device mode demos, bootloaders and projects. Fix errors in the MouseHostWithParser demo from incorrect use of the HID_ALIGN_DATA() macro.
* Double bank CDC endpoints in the XPLAIN Bridge project, re-enable JTAG once ↵Dean Camera2010-03-211-2/+6
| | | | the mode selection pin has been sampled.
* Remove redundant check in the software PDI programming code of the AVRISP ↵Dean Camera2010-03-171-4/+0
| | | | project.
* Software PDI mode breaks unless the software USART has 100 cycles between bits.Dean Camera2010-03-175-13/+14
|
* Increased throughput of the USBtoSerial demo on systems that send multiple ↵Dean Camera2010-03-161-2/+2
| | | | bytes per packet (thanks to Opendous Inc.).
* Don't enable the pullup on the target /RESET line in the AVRISP project for ↵Dean Camera2010-03-161-4/+3
| | | | PDI mode - clearing the XMEGA's reset control register twice is enough to release it from reset. Possible silicon bug, since the official Atmel programmers have the same issue.
* Fixed PDI programming mode in the AVRISP programmer project not exiting ↵Dean Camera2010-03-162-16/+15
| | | | | | programming mode correctly (clear target Reset key twice, set /RESET pin to pullup). Add newlines to the MIDI event printf() statements in the MIDI host demos.
* Added ENABLE_TELNET_SERVER compile time option to the Webserver project to ↵Dean Camera2010-03-107-22/+42
| | | | | | disable the TELNET server if desired. Change over static strings in the Webserver project to use PROGMEM where possible.
* Fix incorrect LED mask name in the Webserver project.Dean Camera2010-03-091-1/+1
| | | | Fix missing text from the Host Mode States enum documentation.
* Webserver project now uses the board LEDs to indicate the current IP ↵Dean Camera2010-03-096-10/+22
| | | | | | configuration state. Don't double-read data from the attached disk in the incomplete StandaloneProgrammer project when in host mode.
* Added a timeout value to the TWI_StartTransmission() function, within which ↵Dean Camera2010-02-242-7/+7
| | | | | | the addressed device must respond. Fixed TWI_StartTransmission() corrupting the contents of the GPIOR0 register.
* Revert changes made for the partial port to the AVR32 architecture.Dean Camera2010-02-243-37/+37
|
* Update Temperature board driver to be AVR32 compatible when the ADC ↵Dean Camera2010-02-232-36/+36
| | | | | | peripheral driver is eventually ported. Make architecture includes explicit for both the AVR32 and the AVR8, to make way for future architecture ports. Add SPI driver aliases for the old function names in the AVR8 driver, so that existing code will still compile against the new version.
* Fixed software PDI/TPI programming mode in the AVRISP project not correctly ↵Dean Camera2010-02-231-2/+2
| | | | | | toggling just the clock pin. Fix broken AVR8 Serial peripheral driver.
* Oops - need to revert changes made to ease testing of the software PDI ↵Dean Camera2010-02-213-22/+3
| | | | programming mode.
* Remove dual ISR for software PDI mode, use a single ISR instead to reduce ↵Dean Camera2010-02-213-43/+55
| | | | code complexity.
* More fixes to the AVRISP command timeout system so that it should no longer ↵Dean Camera2010-02-218-31/+58
| | | | lock up while processing command no matter what the conditions.
* Increased the speed of both software and hardware TPI/PDI programming modes ↵Dean Camera2010-02-213-5/+9
| | | | of the AVRISP project.
* Oops - missed a few references to the old global TimeoutMSRemaining counter ↵Dean Camera2010-02-201-5/+18
| | | | in ISPTarget.c of the AVRISP-MKII clone project.
* AVRISP programmer project now has a more robust timeout system, allowing for ↵Dean Camera2010-02-196-66/+111
| | | | a doubling of the software USART speed for PDI and TPI programming.
* Commit for the 100219 release.Dean Camera2010-02-192-12/+10
|
* Use a temporary variable to hold the current URI length in the Webserver, ↵Dean Camera2010-02-183-13/+12
| | | | rather than calling strlen() multiple times on an unchanged buffer. Clean up uip-split.c.
* Turn OFF double banking in the Webserver demo - leaving it on seems to ↵Dean Camera2010-02-182-4/+4
| | | | destroy the system throughput.
generated by cgit v1.2.3 (git 2.25.1) at 2024-11-13 13:38:37 +0000