1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
|
From 0fec1c81707f5335d0b04b5e97d2ddd0b902377b Mon Sep 17 00:00:00 2001
From: Lad Prabhakar <prabhakar.mahadev-lad.rj@bp.renesas.com>
Date: Tue, 10 Mar 2020 14:17:07 +0100
Subject: [PATCH] media: i2c: imx219: Fix power sequence
Commit ca45448a56659c6df6e0436188e97f6cc65dea8a upstream.
When supporting Rpi Camera v2 Module on the RZ/G2E, found the driver had
some issues with rcar mipi-csi driver. The sensor never entered into LP-11
state.
The powerup sequence in the datasheet[1] shows the sensor entering into
LP-11 in streaming mode, so to fix this issue transitions are performed
from "streaming -> standby" in the probe() after power up.
With this commit the sensor is able to enter LP-11 mode during power up,
as expected by some CSI-2 controllers.
[1] https://publiclab.org/system/images/photos/000/023/294/original/
RASPBERRY_PI_CAMERA_V2_DATASHEET_IMX219PQH5_7.0.0_Datasheet_XXX.PDF
Signed-off-by: Lad Prabhakar <prabhakar.mahadev-lad.rj@bp.renesas.com>
Acked-by: Dave Stevenson <dave.stevenson@raspberrypi.com>
Signed-off-by: Sakari Ailus <sakari.ailus@linux.intel.com>
Signed-off-by: Mauro Carvalho Chehab <mchehab+huawei@kernel.org>
---
drivers/media/i2c/imx219.c | 17 +++++++++++++++++
1 file changed, 17 insertions(+)
--- a/drivers/media/i2c/imx219.c
+++ b/drivers/media/i2c/imx219.c
@@ -1224,6 +1224,23 @@ static int imx219_probe(struct i2c_clien
/* Set default mode to max resolution */
imx219->mode = &supported_modes[0];
+ /* sensor doesn't enter LP-11 state upon power up until and unless
+ * streaming is started, so upon power up switch the modes to:
+ * streaming -> standby
+ */
+ ret = imx219_write_reg(imx219, IMX219_REG_MODE_SELECT,
+ IMX219_REG_VALUE_08BIT, IMX219_MODE_STREAMING);
+ if (ret < 0)
+ goto error_power_off;
+ usleep_range(100, 110);
+
+ /* put sensor back to standby mode */
+ ret = imx219_write_reg(imx219, IMX219_REG_MODE_SELECT,
+ IMX219_REG_VALUE_08BIT, IMX219_MODE_STANDBY);
+ if (ret < 0)
+ goto error_power_off;
+ usleep_range(100, 110);
+
ret = imx219_init_controls(imx219);
if (ret)
goto error_power_off;
|
