aboutsummaryrefslogtreecommitdiffstats
path: root/target/linux/bcm27xx/patches-5.4/950-0474-gpio-ir-overlay-add-parameter-to-configure-signal-po.patch
blob: cdd14f79408a478e78244b1a98627f21267554fa (plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
From e253d03936265dc4ab8ae9ae89d2a885e80a45a6 Mon Sep 17 00:00:00 2001
From: Matthias Reichl <hias@horus.com>
Date: Fri, 6 Mar 2020 11:08:10 +0100
Subject: [PATCH] gpio-ir-overlay: add parameter to configure signal
 polarity (#3490)

Standard IR receivers use inverted / active-low signalling
and the gpio-ir overlay configures the GPIO appropriately
as GPIO_ACTIVE_LOW (1).

In order to support (rather rare) non-inverted / active-high
signalling the GPIO needs to be configured as GPIO_ACTIVE_HIGH (0).

Add an "invert" parameter to override this like in the gpio-ir-tx
overlay.

Signed-off-by: Matthias Reichl <hias@horus.com>
---
 arch/arm/boot/dts/overlays/README              | 4 ++++
 arch/arm/boot/dts/overlays/gpio-ir-overlay.dts | 1 +
 2 files changed, 5 insertions(+)

--- a/arch/arm/boot/dts/overlays/README
+++ b/arch/arm/boot/dts/overlays/README
@@ -754,6 +754,10 @@ Params: gpio_pin                Input pi
         gpio_pull               Desired pull-up/down state (off, down, up)
                                 Default is "up".
 
+        invert                  "1" = invert the input (active-low signalling).
+                                "0" = non-inverted input (active-high
+                                signalling). Default is "1".
+
         rc-map-name             Default rc keymap (can also be changed by
                                 ir-keytable), defaults to "rc-rc6-mce"
 
--- a/arch/arm/boot/dts/overlays/gpio-ir-overlay.dts
+++ b/arch/arm/boot/dts/overlays/gpio-ir-overlay.dts
@@ -42,6 +42,7 @@
                                 <&gpio_ir_pins>,"brcm,pins:0",
                                 <&gpio_ir_pins>,"reg:0";
                 gpio_pull = <&gpio_ir_pins>,"brcm,pull:0";              // pull-up/down state
+                invert = <&gpio_ir>,"gpios:8";                          // 0 = active high input
 
                 rc-map-name = <&gpio_ir>,"linux,rc-map-name";           // default rc map
         };