1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
|
--- a/drivers/gpio/Kconfig
+++ b/drivers/gpio/Kconfig
@@ -341,6 +341,13 @@ config GPIO_IXP4XX
IXP4xx series of chips.
If unsure, say N.
+
+config GPIO_LATCH
+ tristate "MikroTik RouterBOARD GPIO latch support"
+ depends on ATH79
+ help
+ GPIO driver for latch on some MikroTik RouterBOARDs.
+
config GPIO_LOGICVC
tristate "Xylon LogiCVC GPIO support"
depends on MFD_SYSCON && OF
@@ -495,6 +502,10 @@ config GPIO_REG
A 32-bit single register GPIO fixed in/out implementation. This
can be used to represent any register as a set of GPIO signals.
+config GPIO_RB91X_KEY
+ tristate "MikroTik RB91x board series reset key support"
+ depends on ATH79
+
config GPIO_SAMA5D2_PIOBU
tristate "SAMA5D2 PIOBU GPIO support"
depends on MFD_SYSCON
--- a/drivers/gpio/Makefile
+++ b/drivers/gpio/Makefile
@@ -72,6 +72,7 @@ obj-$(CONFIG_GPIO_IT87) += gpio-it87.o
obj-$(CONFIG_GPIO_IXP4XX) += gpio-ixp4xx.o
obj-$(CONFIG_GPIO_JANZ_TTL) += gpio-janz-ttl.o
obj-$(CONFIG_GPIO_KEMPLD) += gpio-kempld.o
+obj-$(CONFIG_GPIO_LATCH) += gpio-latch.o
obj-$(CONFIG_GPIO_LOGICVC) += gpio-logicvc.o
obj-$(CONFIG_GPIO_LOONGSON1) += gpio-loongson1.o
obj-$(CONFIG_GPIO_LOONGSON) += gpio-loongson.o
@@ -121,6 +122,7 @@ obj-$(CONFIG_GPIO_PMIC_EIC_SPRD) += gpio
obj-$(CONFIG_GPIO_PXA) += gpio-pxa.o
obj-$(CONFIG_GPIO_RASPBERRYPI_EXP) += gpio-raspberrypi-exp.o
obj-$(CONFIG_GPIO_RB4XX) += gpio-rb4xx.o
+obj-$(CONFIG_GPIO_RB91X_KEY) += gpio-rb91x-key.o
obj-$(CONFIG_GPIO_RC5T583) += gpio-rc5t583.o
obj-$(CONFIG_GPIO_RCAR) += gpio-rcar.o
obj-$(CONFIG_GPIO_RDA) += gpio-rda.o
--- a/drivers/mtd/nand/raw/Kconfig
+++ b/drivers/mtd/nand/raw/Kconfig
@@ -571,4 +571,10 @@ config MTD_NAND_RB4XX
Enables support for the NAND flash chip on Mikrotik Routerboard
RB4xx series.
+config MTD_NAND_RB91X
+ tristate "MikroTik RB91x NAND driver support"
+ depends on ATH79 && MTD_RAW_NAND
+ help
+ Enables support for the NAND flash chip on MikroTik RB91x series.
+
endif # MTD_RAW_NAND
--- a/drivers/mtd/nand/raw/Makefile
+++ b/drivers/mtd/nand/raw/Makefile
@@ -60,6 +60,7 @@ obj-$(CONFIG_MTD_NAND_CADENCE) += caden
obj-$(CONFIG_MTD_NAND_ARASAN) += arasan-nand-controller.o
obj-$(CONFIG_MTD_NAND_AR934X) += ar934x_nand.o
obj-$(CONFIG_MTD_NAND_RB4XX) += nand_rb4xx.o
+obj-$(CONFIG_MTD_NAND_RB91X) += rb91x_nand.o
nand-objs := nand_base.o nand_legacy.o nand_bbt.o nand_timings.o nand_ids.o
nand-objs += nand_onfi.o
|
