// SPDX-License-Identifier: GPL-2.0-or-later #include "mt7620a.dtsi" #include #include / { compatible = "wavlink,wl-wn535k1", "ralink,mt7620a-soc"; model = "Wavlink WL-WN535K1"; aliases { label-mac-device = &wifi0; led-boot = &led_status_blue; led-failsafe = &led_status_red; led-running = &led_status_blue; led-upgrade = &led_status_red; }; keys { compatible = "gpio-keys"; reset { label = "reset"; gpios = <&gpio0 1 GPIO_ACTIVE_LOW>; linux,code = ; }; touchlink { label = "touchlink"; gpios = <&gpio0 11 GPIO_ACTIVE_LOW>; linux,code = ; }; }; leds { compatible = "gpio-leds"; led_status_blue: status_blue { label = "blue:status"; gpios = <&gpio0 9 GPIO_ACTIVE_HIGH>; }; led_status_red: status_red { label = "red:status"; gpios = <&gpio0 14 GPIO_ACTIVE_HIGH>; }; lan1 { label = "green:lan1"; gpios = <&gpio2 3 GPIO_ACTIVE_LOW>; }; lan2 { label = "green:lan2"; gpios = <&gpio2 2 GPIO_ACTIVE_LOW>; }; wan { label = "green:wan"; gpios = <&gpio2 4 GPIO_ACTIVE_LOW>; }; }; }; &gpio2 { status = "okay"; }; &spi0 { status = "okay"; flash@0 { compatible = "jedec,spi-nor"; reg = <0>; spi-max-frequency = <50000000>; partitions { compatible = "fixed-partitions"; #address-cells = <1>; #size-cells = <1>; partition@0 { label = "u-boot"; reg = <0x0 0x30000>; read-only; }; partition@30000 { label = "config"; reg = <0x30000 0x10000>; read-only; }; factory: partition@40000 { label = "factory"; reg = <0x40000 0x10000>; read-only; compatible = "nvmem-cells"; #address-cells = <1>; #size-cells = <1>; macaddr_factory_28: macaddr@28 { reg = <0x28 0x6>; }; }; partition@50000 { compatible = "denx,uimage"; label = "firmware"; reg = <0x50000 0x730000>; }; partition@780000 { label = "vendor"; reg = <0x780000 0x80000>; read-only; }; }; }; }; &pcie { status = "okay"; }; &pcie0 { wifi0: wifi@0,0 { reg = <0x0000 0 0 0 0>; mediatek,mtd-eeprom = <&factory 0x8000>; ieee80211-freq-limit = <5000000 6000000>; }; }; ðernet { pinctrl-names = "default"; pinctrl-0 = <&rgmii1_pins &rgmii2_pins &mdio_pins>; nvmem-cells = <&macaddr_factory_28>; nvmem-cell-names = "mac-address"; mediatek,portmap = "llllw"; port@4 { status = "okay"; phy-handle = <&phy4>; phy-mode = "rgmii"; }; port@5 { status = "okay"; phy-handle = <&phy5>; phy-mode = "rgmii"; }; mdio-bus { status = "okay"; phy4: ethernet-phy@4 { reg = <4>; phy-mode = "rgmii"; }; phy5: ethernet-phy@5 { reg = <5>; phy-mode = "rgmii"; }; }; }; &gsw { mediatek,port4-gmac; }; &wmac { ralink,mtd-eeprom = <&factory 0x0>; }; &state_default { gpio { groups = "ephy", "i2c", "uartf"; function = "gpio"; }; };