Content-Type: text/plain; charset="utf-8" MIME-Version: 1.0 Content-Transfer-Encoding: 7bit Subject: [v6,1/2] dt/bindings: qcom_adm: Fix channel specifiers From: Andy Gross X-Patchwork-Id: 6027361 Message-Id: <1426571172-9711-2-git-send-email-agross@codeaurora.org> To: Vinod Koul Cc: devicetree@vger.kernel.org, dmaengine@vger.kernel.org, linux-arm-msm@vger.kernel.org, linux-kernel@vger.kernel.org, linux-arm-kernel@lists.infradead.org, Kumar Gala , Bjorn Andersson , Andy Gross Date: Tue, 17 Mar 2015 00:46:11 -0500 This patch removes the crci information from the dma channel property. At least one client device requires using more than one CRCI value for a channel. This does not match the current binding and the crci information needs to be removed. Instead, the client device will provide this information via other means. Signed-off-by: Andy Gross --- Documentation/devicetree/bindings/dma/qcom_adm.txt | 16 ++++++---------- 1 file changed, 6 insertions(+), 10 deletions(-) --- a/Documentation/devicetree/bindings/dma/qcom_adm.txt +++ b/Documentation/devicetree/bindings/dma/qcom_adm.txt @@ -4,8 +4,7 @@ Required properties: - compatible: must contain "qcom,adm" for IPQ/APQ8064 and MSM8960 - reg: Address range for DMA registers - interrupts: Should contain one interrupt shared by all channels -- #dma-cells: must be <2>. First cell denotes the channel number. Second cell - denotes CRCI (client rate control interface) flow control assignment. +- #dma-cells: must be <1>. First cell denotes the channel number. - clocks: Should contain the core clock and interface clock. - clock-names: Must contain "core" for the core clock and "iface" for the interface clock. @@ -22,7 +21,7 @@ Example: compatible = "qcom,adm"; reg = <0x18300000 0x100000>; interrupts = <0 170 0>; - #dma-cells = <2>; + #dma-cells = <1>; clocks = <&gcc ADM0_CLK>, <&gcc ADM0_PBUS_CLK>; clock-names = "core", "iface"; @@ -35,15 +34,12 @@ Example: qcom,ee = <0>; }; -DMA clients must use the format descripted in the dma.txt file, using a three +DMA clients must use the format descripted in the dma.txt file, using a two cell specifier for each channel. -Each dmas request consists of 3 cells: +Each dmas request consists of two cells: 1. phandle pointing to the DMA controller 2. channel number - 3. CRCI assignment, if applicable. If no CRCI flow control is required, use 0. - The CRCI is used for flow control. It identifies the peripheral device that - is the source/destination for the transferred data. Example: @@ -56,7 +52,7 @@ Example: cs-gpios = <&qcom_pinmux 20 0>; - dmas = <&adm_dma 6 9>, - <&adm_dma 5 10>; + dmas = <&adm_dma 6>, + <&adm_dma 5>; dma-names = "rx", "tx"; };