From 599e7165ec6477139dae4f32a12e8d49d5dd8859 Mon Sep 17 00:00:00 2001 From: Eric Anholt Date: Mon, 9 May 2016 17:28:18 -0700 Subject: [PATCH] clk: bcm2835: Mark GPIO clocks enabled at boot as critical. These divide off of PLLD_PER and are used for the ethernet and wifi PHYs source PLLs. Neither of them is currently represented by a phy device that would grab the clock for us. This keeps other drivers from killing the networking PHYs when they disable their own clocks and trigger PLLD_PER's refcount going to 0. v2: Skip marking as critical if they aren't on at boot. Signed-off-by: Eric Anholt --- drivers/clk/bcm/clk-bcm2835.c | 9 +++++++++ 1 file changed, 9 insertions(+) --- a/drivers/clk/bcm/clk-bcm2835.c +++ b/drivers/clk/bcm/clk-bcm2835.c @@ -1268,6 +1268,15 @@ static struct clk_hw *bcm2835_register_c init.name = data->name; init.flags = data->flags | CLK_IGNORE_UNUSED; + /* + * Some GPIO clocks for ethernet/wifi PLLs are marked as + * critical (since some platforms use them), but if the + * firmware didn't have them turned on then they clearly + * aren't actually critical. + */ + if ((cprman_read(cprman, data->ctl_reg) & CM_ENABLE) == 0) + init.flags &= ~CLK_IS_CRITICAL; + if (data->is_vpu_clock) { init.ops = &bcm2835_vpu_clock_clk_ops; } else {