From 832d2f1df231073ac72474743e3d3adbf0540030 Mon Sep 17 00:00:00 2001 From: Eric Anholt Date: Mon, 9 May 2016 17:28:18 -0700 Subject: [PATCH] clk: bcm2835: Mark GPIO clocks enabled at boot as critical. These divide off of PLLD_PER and are used for the ethernet and wifi PHYs source PLLs. Neither of them is currently represented by a phy device that would grab the clock for us. This keeps other drivers from killing the networking PHYs when they disable their own clocks and trigger PLLD_PER's refcount going to 0. v2: Skip marking as critical if they aren't on at boot. Signed-off-by: Eric Anholt --- drivers/clk/bcm/clk-bcm2835.c | 13 ++++++++++++- 1 file changed, 12 insertions(+), 1 deletion(-) --- a/drivers/clk/bcm/clk-bcm2835.c +++ b/drivers/clk/bcm/clk-bcm2835.c @@ -1246,6 +1246,15 @@ static struct clk *bcm2835_register_cloc init.name = data->name; init.flags = data->flags | CLK_IGNORE_UNUSED; + /* + * Some GPIO clocks for ethernet/wifi PLLs are marked as + * critical (since some platforms use them), but if the + * firmware didn't have them turned on then they clearly + * aren't actually critical. + */ + if ((cprman_read(cprman, data->ctl_reg) & CM_ENABLE) == 0) + init.flags &= ~CLK_IS_CRITICAL; + if (data->is_vpu_clock) { init.ops = &bcm2835_vpu_clock_clk_ops; } else { @@ -1720,13 +1729,15 @@ static const struct bcm2835_clk_desc clk .div_reg = CM_GP1DIV, .int_bits = 12, .frac_bits = 12, + .flags = CLK_IS_CRITICAL, .is_mash_clock = true), [BCM2835_CLOCK_GP2] = REGISTER_PER_CLK( .name = "gp2", .ctl_reg = CM_GP2CTL, .div_reg = CM_GP2DIV, .int_bits = 12, - .frac_bits = 12), + .frac_bits = 12, + .flags = CLK_IS_CRITICAL), /* HDMI state machine */ [BCM2835_CLOCK_HSM] = REGISTER_PER_CLK(