From fd898e41ab16efaab945e7b5e65908711b8095af Mon Sep 17 00:00:00 2001 From: Phil Elwell Date: Tue, 17 Nov 2015 10:07:08 +0000 Subject: [PATCH 218/222] BCM270X_DT: Fix overlay README anomalies --- arch/arm/boot/dts/overlays/README | 13 ++++++------- 1 file changed, 6 insertions(+), 7 deletions(-) --- a/arch/arm/boot/dts/overlays/README +++ b/arch/arm/boot/dts/overlays/README @@ -227,7 +227,7 @@ Params: gpio_pin Input p Name: gpio-poweroff Info: Drives a GPIO high or low on reboot -Load: gpio-poweroff,= +Load: dtoverlay=gpio-poweroff,= Params: gpiopin GPIO for signalling (default 26) active_low Set if the power control device requires a @@ -302,7 +302,7 @@ Params: speed Display Name: i2c-gpio Info: Adds support for software i2c controller on gpio pins -Load: dtoverlay=i2c-gpio, +Load: dtoverlay=i2c-gpio,= Params: i2c_gpio_sda GPIO used for I2C data (default "23") i2c_gpio_scl GPIO used for I2C clock (default "24") @@ -313,7 +313,7 @@ Params: i2c_gpio_sda GPIO us Name: i2c-rtc Info: Adds support for a number of I2C Real Time Clock devices -Load: dtoverlay=i2c-rtc, +Load: dtoverlay=i2c-rtc,= Params: ds1307 Select the DS1307 device ds3231 Select the DS3231 device @@ -348,7 +348,7 @@ Params: Name: lirc-rpi Info: Configures lirc-rpi (Linux Infrared Remote Control for Raspberry Pi) Consult the module documentation for more details. -Load: dtoverlay=lirc-rpi,=,... +Load: dtoverlay=lirc-rpi,= Params: gpio_out_pin GPIO for output (default "17") gpio_in_pin GPIO for input (default "18") @@ -440,7 +440,7 @@ Params: speed Display Name: piscreen2r Info: PiScreen 2 with resistive TP display by OzzMaker.com -Load: dtoverlay=piscreen,= +Load: dtoverlay=piscreen2r,= Params: speed Display SPI bus speed rotate Display rotation {0,90,180,270} @@ -505,7 +505,6 @@ Info: Configures a single PWM channel 3) So be careful mixing audio and PWM. 4) Currently the clock must have been enabled and configured by other means. -Load: dtoverlay=pwm-2chan,= Load: dtoverlay=pwm,= Params: pin Output pin (default 18) - see table func Pin function (default 2 = Alt5) - see above @@ -708,7 +707,7 @@ Params: gpiopin GPIO fo Name: w1-gpio-pullup Info: Configures the w1-gpio Onewire interface module. Use this overlay if you *do* need a GPIO to drive an external pullup. -Load: dtoverlay=w1-gpio-pullup,=,... +Load: dtoverlay=w1-gpio-pullup,= Params: gpiopin GPIO for I/O (default "4") pullup Non-zero, "on", or "y" to enable the parasitic