From ac0b202c0bae166810c63e2ac5067b6ea3f4af43 Mon Sep 17 00:00:00 2001 From: Maxime Ripard Date: Mon, 17 Jan 2022 17:31:06 +0100 Subject: [PATCH] clk: bcm: rpi: Set a default minimum rate The M2MC clock provides the state machine clock for both HDMI controllers. However, if no HDMI monitor is plugged in at boot, its clock rate will be left at 0 by the firmware and will make any register access end up in a CPU stall, even though the clock was enabled. We had some code in the HDMI controller to deal with this before, but it makes more sense to have it in the clock driver. Move it there. Signed-off-by: Maxime Ripard --- drivers/clk/bcm/clk-raspberrypi.c | 26 ++++++++++++++++++++++++++ 1 file changed, 26 insertions(+) --- a/drivers/clk/bcm/clk-raspberrypi.c +++ b/drivers/clk/bcm/clk-raspberrypi.c @@ -78,6 +78,7 @@ struct raspberrypi_clk_data { struct raspberrypi_clk_variant { bool export; char *clkdev; + unsigned long min_rate; }; static struct raspberrypi_clk_variant @@ -91,6 +92,18 @@ raspberrypi_clk_variants[RPI_FIRMWARE_NU }, [RPI_FIRMWARE_M2MC_CLK_ID] = { .export = true, + + /* + * If we boot without any cable connected to any of the + * HDMI connector, the firmware will skip the HSM + * initialization and leave it with a rate of 0, + * resulting in a bus lockup when we're accessing the + * registers even if it's enabled. + * + * Let's put a sensible default so that we don't end up + * in this situation. + */ + .min_rate = 120000000, }, [RPI_FIRMWARE_V3D_CLK_ID] = { .export = true, @@ -278,6 +291,19 @@ static struct clk_hw *raspberrypi_clk_re } } + if (variant->min_rate) { + unsigned long rate; + + clk_hw_set_rate_range(&data->hw, variant->min_rate, max_rate); + + rate = raspberrypi_fw_get_rate(&data->hw, 0); + if (rate < variant->min_rate) { + ret = raspberrypi_fw_set_rate(&data->hw, variant->min_rate, 0); + if (ret) + return ERR_PTR(ret); + } + } + return &data->hw; }