From faa24f47c0066893e0b7772befe378bde4dc2ff9 Mon Sep 17 00:00:00 2001 From: Maxime Ripard Date: Mon, 25 Oct 2021 17:28:54 +0200 Subject: [PATCH] drm/vc4: hdmi: Remove the DDC probing for status detection Commit 9d44abbbb8d5 ("drm/vc4: Fall back to using an EDID probe in the absence of a GPIO.") added some code to read the EDID through DDC in the HDMI driver detect hook since the Pi3 had no HPD GPIO back then. However, commit b1b8f45b3130 ("ARM: dts: bcm2837: Add missing GPIOs of Expander") changed that a couple of years later. This causes an issue though since some TV (like the LG 55C8) when it comes out of standy will deassert the HPD line, but the EDID will remain readable. It causes an issues nn platforms without an HPD GPIO, like the Pi4, where the DDC probing will be our primary mean to detect a display, and thus we will never detect the HPD pulse. This was fine before since the pulse was small enough that we would never detect it, and we also didn't have anything (like the scrambler) that needed to be set up in the display. However, now that we have both, the display during the HPD pulse will clear its scrambler status, and since we won't detect the disconnect/reconnect cycle we will never enable the scrambler back. As our main reason for that DDC probing is gone, let's just remove it. Signed-off-by: Maxime Ripard Reviewed-by: Dave Stevenson Link: https://lore.kernel.org/r/20211025152903.1088803-2-maxime@cerno.tech --- drivers/gpu/drm/vc4/vc4_hdmi.c | 2 -- 1 file changed, 2 deletions(-) --- a/drivers/gpu/drm/vc4/vc4_hdmi.c +++ b/drivers/gpu/drm/vc4/vc4_hdmi.c @@ -179,8 +179,6 @@ vc4_hdmi_connector_detect(struct drm_con if (vc4_hdmi->hpd_gpio) { if (gpiod_get_value_cansleep(vc4_hdmi->hpd_gpio)) connected = true; - } else if (drm_probe_ddc(vc4_hdmi->ddc)) { - connected = true; } else if (HDMI_READ(HDMI_HOTPLUG) & VC4_HDMI_HOTPLUG_CONNECTED) { connected = true; }