// SPDX-License-Identifier: GPL-2.0-or-later OR MIT /dts-v1/; #include #include #include "qca9557.dtsi" / { model = "TP-Link RE350K v1"; compatible = "tplink,re350k-v1", "qca,qca9558"; aliases { led-boot = &led_power; led-failsafe = &led_power; led-running = &led_power; led-upgrade = &led_power; mdio-gpio0 = &mdio2; }; chosen { bootargs = "console=ttyS0,115200n8"; }; keys { compatible = "gpio-keys"; app-config { label = "app-config"; linux,code = ; gpios = <&gpio 20 GPIO_ACTIVE_LOW>; debounce-interval = <60>; }; led { label = "led"; linux,code = ; gpios = <&gpio 19 GPIO_ACTIVE_LOW>; debounce-interval = <60>; }; reset { label = "reset"; linux,code = ; gpios = <&gpio 17 GPIO_ACTIVE_LOW>; debounce-interval = <60>; }; }; leds { compatible = "gpio-leds"; led_power: power { label = "tp-link:green:power"; gpios = <&gpio 12 GPIO_ACTIVE_LOW>; default-state = "on"; }; wlan2g_green { label = "tp-link:green:wlan2g"; gpios = <&gpio 16 GPIO_ACTIVE_LOW>; linux,default-trigger = "phy1tpt"; }; wlan2g_red { label = "tp-link:red:wlan2g"; gpios = <&gpio 21 GPIO_ACTIVE_LOW>; }; wlan5g_green { label = "tp-link:green:wlan5g"; gpios = <&gpio 14 GPIO_ACTIVE_LOW>; linux,default-trigger = "phy0tpt"; }; wlan5g_red { label = "tp-link:red:wlan5g"; gpios = <&gpio 22 GPIO_ACTIVE_LOW>; }; }; mdio2: mdio { compatible = "virtual,mdio-gpio"; #address-cells = <1>; #size-cells = <0>; gpios = <&gpio 23 GPIO_ACTIVE_HIGH>, <&gpio 18 GPIO_ACTIVE_HIGH>; phy4: ethernet-phy@4 { reg = <4>; phy-mode = "rgmii-rxid"; eee-broken-100tx; eee-broken-1000t; }; }; }; ð0 { status = "okay"; phy-handle = <&phy4>; pll-data = <0x9e000000 0x80000101 0x80001313>; mtd-mac-address = <&config 0x10008>; gmac-config { device = <&gmac>; rxdv-delay = <2>; rxd-delay = <2>; txen-delay = <0>; txd-delay = <0>; rgmii-enabled = <1>; }; }; &pcie0 { status = "okay"; }; &spi { status = "okay"; num-cs = <1>; flash@0 { compatible = "jedec,spi-nor"; reg = <0>; spi-max-frequency = <25000000>; partitions { compatible = "fixed-partitions"; #address-cells = <1>; #size-cells = <1>; partition@0 { label = "u-boot"; reg = <0x000000 0x020000>; read-only; }; partition@20000 { compatible = "tplink,firmware"; label = "firmware"; reg = <0x020000 0xd70000>; }; config: partition@d90000 { label = "config"; reg = <0xd90000 0x260000>; read-only; }; art: partition@ff0000 { label = "art"; reg = <0xff0000 0x010000>; read-only; }; }; }; }; &uart { status = "okay"; }; &wmac { status = "okay"; mtd-cal-data = <&art 0x1000>; mtd-mac-address = <&config 0x10008>; };