From a4e9c8f14b63cd44300ed452312c03a69aae9ca1 Mon Sep 17 00:00:00 2001 From: Sungbo Eo Date: Tue, 12 Nov 2019 01:23:07 +0900 Subject: ramips: add support for netis WF2770 netis WF2770 is a 2.4/5GHz band AC750 router, based on MediaTek MT7620A. Specifications: - SoC: MT7620A - RAM: DDR2 64MB - Flash: SPI NOR 16MB - WiFi: - 2.4GHz: SoC internal - 5GHz: MT7610EN - Ethernet: 5x 10/100/1000Mbps - Switch: MT7530BU - UART: - J2: 3.3V, RX, TX, GND (3.3V is the square pad) / 57600 8N1 MAC addresses in factory partition: 0x0004: LAN, WiFi 2.4GHz (label_mac-6) 0x0028: not used (label_mac-1) 0x002e: WAN (label_mac) 0x8004: WiFi 5GHz (label_mac+2) Installation via web interface: 1. Flash **initramfs** image through the stock web interface. 2. Boot into OpenWrt and perform sysupgrade with sysupgrade image. Revert to stock firmware: 1. Perform sysupgrade with stock image. Reviewed-by: Pawel Dembicki Signed-off-by: Sungbo Eo --- target/linux/ramips/mt7620/base-files/etc/board.d/02_network | 5 +++++ 1 file changed, 5 insertions(+) (limited to 'target/linux/ramips/mt7620/base-files') diff --git a/target/linux/ramips/mt7620/base-files/etc/board.d/02_network b/target/linux/ramips/mt7620/base-files/etc/board.d/02_network index 20932f60e9..c1dbf8d71d 100755 --- a/target/linux/ramips/mt7620/base-files/etc/board.d/02_network +++ b/target/linux/ramips/mt7620/base-files/etc/board.d/02_network @@ -170,6 +170,7 @@ ramips_setup_interfaces() "1:lan:4" "2:lan:3" "4:lan:2" "5:lan:1" "0:wan" "6@eth0" ;; linksys,e1700|\ + netis,wf2770|\ ralink,mt7620a-mt7530-evb) ucidef_add_switch "switch0" ucidef_add_switch_attr "switch0" "enable" "false" @@ -338,6 +339,10 @@ ramips_setup_macs() linksys,e1700) wan_mac=$(mtd_get_mac_ascii config WAN_MAC_ADDR) ;; + netis,wf2770) + wan_mac=$(mtd_get_mac_binary factory 0x2e) + label_mac=$wan_mac + ;; tplink,archer-c2-v1|\ tplink,archer-c20-v1|\ tplink,archer-c20i|\ -- cgit v1.2.3