From 6041c693dd4660f1585322c182e83479afb3c381 Mon Sep 17 00:00:00 2001 From: Kyoungkyu Park Date: Sat, 25 Dec 2021 04:48:22 +0900 Subject: ramips: add support for HUMAX E2 HUMAX E2 (also known as HUMAX QUANTUM E2) is a 2.4/5GHz band AC router, based on MediaTek MT7620A. Specifications: - SoC: MT7620A - RAM: DDR2 64MB - Flash: SPI NOR 8MB (MXIC MX25L6405D) - WiFi: - 2.4GHz: SoC internal - 5GHz: MT7610E - Ethernet: 1x 10/100Mbps - Switch: SoC internal - UART: J2 (57600 8N1) - pinout: [3V3] (RXD) (GND) (TXD) Installation and Recovery via TFTP: 1. Connect ethernet cable between Router port and PC Ethernet port. 2. Set your computer to a static IP **192.168.1.1** 3. Turn the device off and wait a few seconds. Hold the WPS button on front of device and insert power. 4. Send a firmware image to **192.168.1.6** using TFTP. You can use any TFTP client. (tftp, curl, Tftpd64...) 5. Wait until Power LED stop flashing. **DO NOT TURN OFF DEVICE!** The device will be automatically rebooted. Signed-off-by: Kyoungkyu Park --- target/linux/ramips/mt7620/base-files/etc/board.d/01_leds | 3 +++ 1 file changed, 3 insertions(+) (limited to 'target/linux/ramips/mt7620/base-files/etc/board.d/01_leds') diff --git a/target/linux/ramips/mt7620/base-files/etc/board.d/01_leds b/target/linux/ramips/mt7620/base-files/etc/board.d/01_leds index 694f3d1541..8d438538fc 100644 --- a/target/linux/ramips/mt7620/base-files/etc/board.d/01_leds +++ b/target/linux/ramips/mt7620/base-files/etc/board.d/01_leds @@ -125,6 +125,9 @@ hnet,c108) ucidef_set_led_netdev "lan" "lan" "green:lan" "eth0" ucidef_set_led_netdev "modem" "modem" "green:modem" "wwan0" ;; +humax,e2) + ucidef_set_led_netdev "lan" "lan" "green:lan" "eth0" + ;; iodata,wn-ac1167gr|\ iodata,wn-ac733gr3) ucidef_set_led_wlan "wlan5g" "WLAN5G" "green:wlan5g" "phy0radio" -- cgit v1.2.3