From f1c193c27e714a051b49788fff3aecbd728190e1 Mon Sep 17 00:00:00 2001 From: Piotr Dymacz Date: Fri, 26 Jan 2018 16:21:34 +0100 Subject: ramips: add support for ALFA Network AWUSFREE1 ALFA Network AWUSFREE1 is an USB Wi-Fi N300 adapter based on MT7628. Specification: - MT7628AN (580 MHz) - 64 MB of RAM (DDR2) - 8 MB of FLASH (SPI NOR) - 2T2R 2.4 GHz (MT7628) with external FEM (RFFM4203) - 2x detachable antennas (RP-SMA) - ASIX AX88772 USB to Ethernet bridge (connected with MT7628 PHY0) - 4x LED (2 driven by GPIO) - 1x button (reset) - 1x mini USB for host and main power input - UART header on PCB Flash instruction: You can use sysupgrade image directly in vendor firmware which is based on LEDE/OpenWrt. Alternatively, you can use web recovery mode in U-Boot: 1. Power device with reset button pressed and release it after ~5 sec. 2. Setup static IP 192.168.1.2/4 on your PC. 3. Go to 192.168.1.1 in browser and upload "sysupgrade" image. Signed-off-by: Piotr Dymacz --- target/linux/ramips/base-files/etc/diag.sh | 3 +++ 1 file changed, 3 insertions(+) (limited to 'target/linux/ramips/base-files/etc/diag.sh') diff --git a/target/linux/ramips/base-files/etc/diag.sh b/target/linux/ramips/base-files/etc/diag.sh index c5f62ab66d..6038804b12 100644 --- a/target/linux/ramips/base-files/etc/diag.sh +++ b/target/linux/ramips/base-files/etc/diag.sh @@ -78,6 +78,9 @@ get_status_led() { wrh-300cr) status_led="$boardname:green:wps" ;; + alfa-network,awusfree1) + status_led="$boardname:orange:system" + ;; all0239-3g|\ dcs-930|\ dir-300-b1|\ -- cgit v1.2.3