From 869376710d70b1e2c9f5265bc8840738794bb280 Mon Sep 17 00:00:00 2001 From: Kristian Evensen Date: Thu, 16 May 2019 15:38:00 +0200 Subject: ramips: Add support for ZBT WE826-E ZBT WE826-E is a dual-SIM version of the ZBT WE826. The router has the following specifications: - MT7620A (580 MHz) - 128MB RAM - 32MB of flash (SPI NOR) - 5x 10/100Mbps Ethernet (MT7620A built-in switch) - 1x microSD slot - 1x miniPCIe slot (only USB2.0 bus) - 2x SIM card slots (standard size) - 1x USB2.0 port - 1x 2.4GHz wifi (rt2800) - 10x LEDs (4 GPIO-controlled) - 1x reset button The following have been tested and working: - Ethernet switch - wifi - miniPCIe slot - USB port - microSD slot - sysupgrade - reset button Installation and recovery: In order to install OpenWRT the first time or recover the router, you can use the web-based recovery system. Keep the reset button pressed during boot and access 192.168.1.1 in your browser when your machine obtains an IP address. Upload the firmware to start the recovery process. How to swap SIMs: You control which SIM slot to use by writing 0/1 to /sys/class/gpio/gpio13/value. In order for the change to take effect, you can either use AT-commands (AT+CFUN) or power-cycle the modem (write 0/1 to /sys/class/gpio/gpio14/value). Signed-off-by: Kristian Evensen --- target/linux/ramips/base-files/etc/board.d/01_leds | 3 ++- 1 file changed, 2 insertions(+), 1 deletion(-) (limited to 'target/linux/ramips/base-files/etc/board.d/01_leds') diff --git a/target/linux/ramips/base-files/etc/board.d/01_leds b/target/linux/ramips/base-files/etc/board.d/01_leds index 9d42720c60..b55ca0413e 100755 --- a/target/linux/ramips/base-files/etc/board.d/01_leds +++ b/target/linux/ramips/base-files/etc/board.d/01_leds @@ -252,7 +252,8 @@ mr200) mtc,wr1201) ucidef_set_led_switch "eth_link" "LAN link" "$boardname:green:eth_link" "switch0" "0x0f" ;; -mzk-ex750np) +mzk-ex750np|\ +zbtlink,zbt-we826-e) set_wifi_led "$boardname:red:wifi" ;; netgear,r6120) -- cgit v1.2.3