From 671c9d16e382bcace441d8ad07816f8ceeed3612 Mon Sep 17 00:00:00 2001 From: Liu Yu Date: Sun, 5 May 2019 10:54:52 +0800 Subject: ramips: add support for HILINK HLK-7628N Specification: CPU: MT7628 580 MHz. MIPS 24K RAM: 128 MB Flash: 32 MB WIFI: 802.11n/g/b 20/40 MHz Ethernet: 5 Port ethernet switch UART: 2x Flash instruction: The U-boot is based on Ralink SDK so we can flash the firmware using UART: 1. Configure PC with a static IP address and setup an TFTP server. 2. Put the firmware into the tftp directory. 3. Connect the UART0 line as described on the PCB. 4. Power up the device and press 2, follow the instruction to set device and tftp server IP address and input the firmware file name. U-boot will then load the firmware and write it into the flash. 5. After firmware is started connect via ethernet at 192.168.1.1 Signed-off-by: Liu Yu Signed-off-by: Christian Lamparter [removed dupped subject] --- target/linux/ramips/base-files/etc/board.d/01_leds | 1 + 1 file changed, 1 insertion(+) (limited to 'target/linux/ramips/base-files/etc/board.d/01_leds') diff --git a/target/linux/ramips/base-files/etc/board.d/01_leds b/target/linux/ramips/base-files/etc/board.d/01_leds index b55ca0413e..ccbe53d770 100755 --- a/target/linux/ramips/base-files/etc/board.d/01_leds +++ b/target/linux/ramips/base-files/etc/board.d/01_leds @@ -17,6 +17,7 @@ case $board in set_wifi_led "$boardname:amber:wlan" ;; 3g-6200nl|\ +hilink,hlk-7628n|\ skylab,skw92a|\ wnce2001) set_wifi_led "$boardname:green:wlan" -- cgit v1.2.3