From cd8b20931ee40a5cdf008e6087b35e7770fc51a1 Mon Sep 17 00:00:00 2001 From: Mathias Kresin Date: Sat, 10 Sep 2016 11:05:56 +0200 Subject: lantiq: xrx200: use vlan for ethernet wan port Using the lantiq,wan device tree property for one interface node and the lantiq,switch device tree property for another interface node at the same time was never intended/isn't supported at the moment. The property is meant to be used in two phy operation mode where one phy is assigned to an interface without lantiq,* device tree property and the other phy is assigned to an interface with the lantiq,wan device property to have two netdevs. If both properties are used at the same time, the lantiq,wan interface is shown as independent netdev but not able to operate independent. The port needs to be managed via swconfig. These dependency is not obvious and fooled already a lot of users. Add a default WAN vlan for xrx200 devices having an ethernet WAN port and remove the lantiq,wan device tree property. Leave it up to the user to set the ethernet WAN port as default WAN interface or to use this port as additional LAN port. Signed-off-by: Mathias Kresin --- target/linux/lantiq/dts/VGV7510KW22.dtsi | 23 ++++++----------------- 1 file changed, 6 insertions(+), 17 deletions(-) (limited to 'target/linux/lantiq/dts/VGV7510KW22.dtsi') diff --git a/target/linux/lantiq/dts/VGV7510KW22.dtsi b/target/linux/lantiq/dts/VGV7510KW22.dtsi index 4f76e7ddf3..73240bf2bc 100644 --- a/target/linux/lantiq/dts/VGV7510KW22.dtsi +++ b/target/linux/lantiq/dts/VGV7510KW22.dtsi @@ -189,6 +189,12 @@ mtd-mac-address = <&boardconfig 0x16>; lantiq,switch; + ethernet@0 { + compatible = "lantiq,xrx200-pdi-port"; + reg = <0>; + phy-mode = "mii"; + phy-handle = <&phy1>; + }; ethernet@2 { compatible = "lantiq,xrx200-pdi-port"; reg = <2>; @@ -215,23 +221,6 @@ }; }; - wan: interface@1 { - compatible = "lantiq,xrx200-pdi"; - #address-cells = <1>; - #size-cells = <0>; - reg = <1>; - mtd-mac-address = <&boardconfig 0x16>; - mtd-mac-address-increment = <3>; - lantiq,wan; - - ethernet@0 { - compatible = "lantiq,xrx200-pdi-port"; - reg = <0>; - phy-mode = "mii"; - phy-handle = <&phy1>; - }; - }; - mdio@0 { #address-cells = <1>; #size-cells = <0>; -- cgit v1.2.3