From 6da319412753ac99a895f09b9735c7f44fd0bf2c Mon Sep 17 00:00:00 2001 From: Edward Matijevic Date: Tue, 23 Jun 2020 14:50:04 -0500 Subject: bcm47xx: add support for NETGEAR R6200 V1 This patch adds supports for the NETGEAR R6200 V1 This device is mainlined in Linux as of 5.4 Specification: - SOC: Broadcom BCM4718A1 (480 MHz) - Flash: 16MB (Macronix MX25L128) - RAM: 128MB DDR2 - SWITCH: BCM53125 - Ethernet: 5x GE (1 WAN + 4 LAN, Inverted order) - WLAN 2.4G: In SOC - WLAN 5GHz: miniPCIe card, BCM4352 (ID: 4360) - USB: 1x USB 2.0 port (Type A) - Buttons: Reset, WLAN, WPS - LED: Amber for Power, others need a workaround - UART: 1x UART on PCB LED Issues: They are controlled by a 74HC164 via bit banging(GPIO 6/7) Firmware Install Instructions ============================= Using the device specific .chk, use that file to perform a normal device upgrade in the OEM admin page. Signed-off-by: Edward Matijevic --- target/linux/bcm47xx/base-files/etc/board.d/01_network | 5 +++++ 1 file changed, 5 insertions(+) (limited to 'target/linux/bcm47xx/base-files/etc') diff --git a/target/linux/bcm47xx/base-files/etc/board.d/01_network b/target/linux/bcm47xx/base-files/etc/board.d/01_network index e6311d8139..41a2077ea1 100755 --- a/target/linux/bcm47xx/base-files/etc/board.d/01_network +++ b/target/linux/bcm47xx/base-files/etc/board.d/01_network @@ -177,6 +177,11 @@ configure_by_model() { "0:wan" "1:lan:4" "2:lan:3" "3:lan:2" "4:lan:1" "8@eth0" ;; + "Netgear R6200 V1") + ucidef_add_switch "switch0" \ + "0:lan:4" "1:lan:3" "2:lan:2" "3:lan:1" "4:wan" "8@eth0" + ;; + "Netgear WN2500RP V1") ucidef_add_switch "switch0" \ "0:lan:4" "1:lan:3" "2:lan:2" "3:lan:1" "5@eth0" -- cgit v1.2.3