From 9703a2adcc9511a8db33427e8110642b6a197873 Mon Sep 17 00:00:00 2001 From: Hauke Mehrtens Date: Sun, 28 Aug 2022 15:09:23 +0200 Subject: kernel: Refresh on 5.10.138 Refresh all patches on top of kernel 5.10.138. The following patches were applied upstream: bcm27xx/patches-5.10/950-0311-drm-vc4-Adopt-the-dma-configuration-from-the-HVS-or-.patch bcm27xx/patches-5.10/950-0317-vc4_hdmi-Remove-firmware-logic-for-MAI-threshold-set.patch bcm27xx/patches-5.10/950-0346-drm-vc4-A-present-but-empty-dmas-disables-audio.patch bcm27xx/patches-5.10/950-0354-drm-vc4-Add-the-2711-HVS-as-a-suitable-DMA-node.patch bcm27xx/patches-5.10/950-0413-drm-vc4-hdmi-Don-t-access-the-connector-state-in-res.patch bcm27xx/patches-5.10/950-0505-vc4-drm-Avoid-full-hdmi-audio-fifo-writes.patch bcm27xx/patches-5.10/950-0512-vc4-drm-vc4_plane-Remove-subpixel-positioning-check.patch bcm27xx/patches-5.10/950-0560-drm-vc4-drv-Remove-the-DSI-pointer-in-vc4_drv.patch bcm27xx/patches-5.10/950-0561-drm-vc4-dsi-Use-snprintf-for-the-PHY-clocks-instead-.patch bcm27xx/patches-5.10/950-0562-drm-vc4-dsi-Introduce-a-variant-structure.patch bcm27xx/patches-5.10/950-0565-drm-vc4-Correct-pixel-order-for-DSI0.patch bcm27xx/patches-5.10/950-0566-drm-vc4-Register-dsi0-as-the-correct-vc4-encoder-typ.patch bcm27xx/patches-5.10/950-0567-drm-vc4-Fix-dsi0-interrupt-support.patch bcm27xx/patches-5.10/950-0568-drm-vc4-Add-correct-stop-condition-to-vc4_dsi_encode.patch bcm27xx/patches-5.10/950-0647-drm-vc4-Fix-timings-for-interlaced-modes.patch bcm27xx/patches-5.10/950-0695-drm-vc4-Fix-margin-calculations-for-the-right-bottom.patch Upstream sets the pixel clock to 340MHz now, do not set it to 600MHz any more. bcm27xx/patches-5.10/950-0576-drm-vc4-hdmi-Raise-the-maximum-clock-rate.patch Fixes: 89956c653252 ("kernel: bump 5.10 to 5.10.138") Fixes: 4209c33ae27d ("kernel: bump 5.10 to 5.10.137") Signed-off-by: Hauke Mehrtens --- ...-0138-usb-add-plumbing-for-updating-interrupt-endpoint-int.patch | 6 +++--- 1 file changed, 3 insertions(+), 3 deletions(-) (limited to 'target/linux/bcm27xx/patches-5.10/950-0138-usb-add-plumbing-for-updating-interrupt-endpoint-int.patch') diff --git a/target/linux/bcm27xx/patches-5.10/950-0138-usb-add-plumbing-for-updating-interrupt-endpoint-int.patch b/target/linux/bcm27xx/patches-5.10/950-0138-usb-add-plumbing-for-updating-interrupt-endpoint-int.patch index db1cdebbbb..a58df1bd13 100644 --- a/target/linux/bcm27xx/patches-5.10/950-0138-usb-add-plumbing-for-updating-interrupt-endpoint-int.patch +++ b/target/linux/bcm27xx/patches-5.10/950-0138-usb-add-plumbing-for-updating-interrupt-endpoint-int.patch @@ -27,7 +27,7 @@ Signed-off-by: Jonathan Bell --- a/drivers/usb/core/hcd.c +++ b/drivers/usb/core/hcd.c -@@ -1966,6 +1966,16 @@ reset: +@@ -1969,6 +1969,16 @@ reset: return ret; } @@ -81,7 +81,7 @@ Signed-off-by: Jonathan Bell extern int usb_driver_set_configuration(struct usb_device *udev, int config); --- a/include/linux/usb/hcd.h +++ b/include/linux/usb/hcd.h -@@ -384,6 +384,11 @@ struct hc_driver { +@@ -385,6 +385,11 @@ struct hc_driver { * or bandwidth constraints. */ void (*reset_bandwidth)(struct usb_hcd *, struct usb_device *); @@ -93,7 +93,7 @@ Signed-off-by: Jonathan Bell /* Returns the hardware-chosen device address */ int (*address_device)(struct usb_hcd *, struct usb_device *udev); /* prepares the hardware to send commands to the device */ -@@ -445,6 +450,8 @@ extern void usb_hcd_unmap_urb_setup_for_ +@@ -446,6 +451,8 @@ extern void usb_hcd_unmap_urb_setup_for_ extern void usb_hcd_unmap_urb_for_dma(struct usb_hcd *, struct urb *); extern void usb_hcd_flush_endpoint(struct usb_device *udev, struct usb_host_endpoint *ep); -- cgit v1.2.3