From 5dfa89be9900819a2796f3ff9c3f395735035f3c Mon Sep 17 00:00:00 2001 From: Piotr Dymacz Date: Fri, 17 Sep 2021 14:52:04 +0200 Subject: ath79: add support for Netgear R6100 Netgear R6100 is a dual-band Wi-Fi 5 (AC1200) router based on Qualcomm Atheros (AR9344 + QCA9882) platform. Support for this device was first introduced in 15f6f67d18 (ar71xx). FCC ID: PY312400225. Specifications: - Atheros AR9344 (560 MHz) - 128 MB of RAM (DDR2) - 128 MB of flash (parallel NAND) - 2T2R 2.4 GHz Wi-Fi (AR9344) - 2T2R 5 GHz Wi-Fi (QCA9882) - 5x 10/100 Mbps Ethernet (AR9344) - 4x internal antenna - 1x USB 2.0 (GPIO-controlled power) - 6x LED, 3x button (reset, Wi-Fi, WPS) - UART (4-pin, 2.54 mm pitch) header on PCB - 1x mechanical power switch - DC jack for main power input (12 V) WARNING: sysupgrade from older stable releases is not possible, fresh installation (via vendor's GUI or TFTP based recovery) is required. Reason for that is increased kernel partition size. Installation: Use the 'factory' image under vendor's GUI or via TFTP U-Boot recovery. You can use the 'nmrpflash' tool at a boot time, before kernel is loaded or start it manually by pressing the 'reset' button for ~20 seconds from powering up the device (U-Boot will start TFTP server on 192.168.1.1, use TFTP client to send the image). Signed-off-by: Enrico Mioso Signed-off-by: Zoltan HERPAI Signed-off-by: Michael Pratt Signed-off-by: Piotr Dymacz --- .../ath79/nand/base-files/etc/hotplug.d/firmware/11-ath10k-caldata | 3 +++ 1 file changed, 3 insertions(+) (limited to 'target/linux/ath79/nand/base-files/etc/hotplug.d') diff --git a/target/linux/ath79/nand/base-files/etc/hotplug.d/firmware/11-ath10k-caldata b/target/linux/ath79/nand/base-files/etc/hotplug.d/firmware/11-ath10k-caldata index 71dfb161e4..03e225ddde 100644 --- a/target/linux/ath79/nand/base-files/etc/hotplug.d/firmware/11-ath10k-caldata +++ b/target/linux/ath79/nand/base-files/etc/hotplug.d/firmware/11-ath10k-caldata @@ -23,6 +23,9 @@ case "$FIRMWARE" in caldata_extract "art" 0x5000 0x844 ath10k_patch_mac $(macaddr_add $(mtd_get_mac_binary art 0x0) 1) ;; + netgear,r6100) + caldata_extract "caldata" 0x5000 0x844 + ;; zyxel,nbg6716) caldata_extract "art" 0x5000 0x844 ath10k_patch_mac $(macaddr_add $(mtd_get_mac_ascii u-boot-env ethaddr) 1) -- cgit v1.2.3