From cb3cd526948af3f69da1af18e035177a0a8f58e3 Mon Sep 17 00:00:00 2001 From: David Bauer Date: Tue, 11 Jun 2019 17:27:51 +0200 Subject: ath79: add support for devolo WiFi pro 1750x Hardware -------- CPU: Qualcomm Atheros QCA9558 RAM: 128M DDR2 FLASH: 16MiB ETH: 1x Atheros AR8035 (PoE in) WiFi2: QCA9558 3T3R WiFi5: QCA9880 3T3R BTN: 1x Reset LED: 1x LED Power (non-controllable) 1x LED Status (internal) 1x LED LAN (controlled by PHY) 1x LED WLAN BEEP: 1x GPIO attached piezo beeper UART: 3.3V GND TX RX (115200-N-8) (3.3V is square pad) Header is located next to external-LED header. Installation ------------ Make sure you set a password for the root user as prompted on first setup! 1. Upload OpenWRT sysupgrade image via SSH to the device. Use /tmp as the destination folder on the device. User is root, password the one set in the web interface. 2. Install OpenWRT with > sysupgrade -n -F /tmp/ Signed-off-by: David Bauer --- target/linux/ath79/image/generic.mk | 9 +++++++++ 1 file changed, 9 insertions(+) (limited to 'target/linux/ath79/image/generic.mk') diff --git a/target/linux/ath79/image/generic.mk b/target/linux/ath79/image/generic.mk index b998cc4062..0836751e2a 100644 --- a/target/linux/ath79/image/generic.mk +++ b/target/linux/ath79/image/generic.mk @@ -263,6 +263,15 @@ define Device/devolo_dvl1750i endef TARGET_DEVICES += devolo_dvl1750i +define Device/devolo_dvl1750x + ATH_SOC := qca9558 + DEVICE_VENDOR := devolo + DEVICE_MODEL := WiFi pro 1750x + DEVICE_PACKAGES := kmod-ath10k-ct ath10k-firmware-qca988x-ct + IMAGE_SIZE := 15936k +endef +TARGET_DEVICES += devolo_dvl1750x + define Device/dlink_dir-825-b1 ATH_SOC := ar7161 DEVICE_VENDOR := D-Link -- cgit v1.2.3